Solenoid and Air System Troubleshooting - Haas Automation Service Video

If you have a problem with a solenoid on your Haas machine, or need advice on how a proper shop air system should work, this video is a must-see. Engineer Andrew Harnett guides you through detailed troubleshooting of solenoids, and demonstrates how to test - and even clean - a solenoid on your machine, so you can be back up and running quickly.
If have any additional questions regarding the steps outlined in this video, please contact your local HFO: bit.ly/1tq3rey.
If you found this video helpful, please hit the like button and share it with a friend who might find it helpful too . . . and thanks!
Follow Haas,
Facebook - / haasautomation
Instagram - / haas_automation
Twitter - / haas_automation

[@emiliohuerta2658]

That is very informative and so useful, thanks to Haas that has made this videos available.

[@davidpyrcz8970]

Very informative, and well done video! Thanks, Haas!

[@keithhansen3963]

Quality videos from a quality company

[@marvincervancia2470]

Thank you for sharing

[@theantichrist6524]

Really good informational video

[@danielvarela7986]

Great job

[@martin42]

Can you direct me towards the brand and type of the reddish-brown pipe sealant you use? I see it used everywhere on my machine and would like to adopt it for the piping of our air system. Thanks!

[@konstantinmironov8890]

Thanks for video! Can you clarify real requirements for compressed air. As I know, HAAS doesn’t required Refrigerated dryers. But after compressor , air has 100% humidity. It will definitely cause water deposit in the air system. But we may not notice water in air gun. I never notice any signs of water in my TM-2p, but after 4 years of using I found doors locks completely corroded. Probably , it would be honest to make a requirement for air dryers before machines.

[@filmer50]

On a VF3 mill. I have alarm 130 tool unclamped. Where can I find what is the exhaust muffler? Is that located in that same panel?

[@chalesmeyers2727]

I cannot fin any info on how to fix an error where the machine is not recognizing some of the pockets

[@157189041]

Hi! I am in Brazil, i'm sorry for my bad English. please talk about protection telescopic. procedures mounting and disassembly and also as the operator must keep it. Have VF4SS.

[@arabarab9033]

hi if you have haas vf4

[@danilovillani7571]

Hi, I have a Haas VF2 machining center from 2002. I get alarm 628, how can I solve this problem?

[@jenspetersen5865]

Sadly this video is missing all the trouble shooting of components supplied with compressed air. When our TM1P (2010) is on significant amounts of air leaks out of the spindle housing both with tool in and tool out you can feel it blowing. This video really needs trouble shooting that is not due to faulty pneumatic components.

[@Xanadon222]

The TM-2P i run seems to randomly give me "Alarm 830" even though it runs perfectly for half the day. Any input into why it might be doing this and what steps I should take to fix it.

[@AleksandarTeodorovic]

Order ferrite filter from Haas and put it on your Z axis encoder cable on the processor board.

[@derekknight7403]

What's 830? Might be a loss of air, or the valve shuddering.

[@earth111]

Emissions