Speedlogix Front and Rear Strut Installation (Dodge Challenger Scat Pack Shaker)

This is an installation video of the front and rear strut bars on my 2019 Dodge Challenger Scat Pack Shaker. If you have any questions do not hesitate to reach out to me. Please like and subscribe for more and thanks for watching!
Links to products:
Speedlogix website:
www.speedlogix...
Speedlogix front strut:
www.speedlogixs...
Speedlogix rear strut:
www.speedlogixs...

[@DominionSinist]

You should remove the fart music from your video.

[@jarrettsmith88]

what color is this one? is this the brembo red or the octane red?

[@Firebender420]

Helpful video BUT left out a lot of key details smh

[@warrenwaymack7366]

Do u still have your template

[@baddbeestl9344]

Which template are you referring to? The trunk mat template?

[@warrenwaymack7366]

Nice work though u had a guide to make cuts I see again . Thanks

[@St.PierreProductions]

What was total time for you to install that? Clean install man. I'm doing the 2 piece one for my shaker.

[@dcpatters0]

Excellent tutorial. Regarding the front strut tower brace installation, the mounting bolt locations, are the front struts, 3 botls per strut, and behind the strut tower? Does the center of the brace bolt anywhere?

[@wolf-bv6lg]

Clean install, well done

[@willardarmbruster8111]

Seems much easier to install Petty front brace for shaker and leaving factory brace intact.

[@toshaheritalvinen6426]

When you were putting the front strut in, what did you do with the metal part that was holding up the wiper motor? I assume the strut took the place of it completely, but wanted to make sure

[@baddbeestl9344]

Sorry I just seen this! But yes the new strut bar takes care of the pre existing metal brace that the windshield wipers motor was on and if you order it through speedlogix they provide a pre drilled spot for the windshield wiper motor to mount to!

[@toshaheritalvinen6426]

@@baddbeestl9344 Thank you very much for the reply!

[@deanpeeples]

Where did you get the wiper motor bracket from? Mine is tack welded on to the factory cross bar. 2020 Redeye...

[@baddbeestl9344]

@@deanpeeplesmine was a bracket that was bolted into the original support bar that was there so I just had to remove it and put the bolts into the new strut bar.(The holes in the new strut bar were pre drilled)

[@baddbeestl9344]

@@deanpeeples I’m sorry the bracket at 5:28 came with the strut bar and is for the windshield motor

[@selborx]

Well done! Do you feel the difference? At what speed have you tested the rigidity or stability of your 392?

[@baddbeestl9344]

There are a few winding roads around me that I could definitely feel a more stable car as well as on a fast acceleration!

[@demodemoncrat441]

This is exactly why I didn't get a shaker. It just complicates EVERYTHING down to putting oil in the car with zero performance gain.