How To Repair A Popcorn Ceiling - Spencer Colgan Part 1

[@cjbarlow61]

The popcorn is falling off because it got wet. We still primer under repairs to help adhesion and cover up any paper showing thru or stains bleeding thru. If you try to roll new popcorn over old, it will start to come off in sheets or large chunks. Best case is scrape off the loose texture, scrape the high ridge along the spot where its removed, and float the edge just a little, then primer it and spray it with a hopper

[@bradamador5398]

Great video and good explanation…He shows why it time to do it right….

[@skorpyo331]

Exactly my problem. Good painters that teach will always be my best friend

[@ensignj3242]

This is the best advise I’ve heard regarding popcorn ceiling repair. This makes sense.

[@chriscastillo6774]

Great job, now this is the man I would love to work for....do it right.

[@nordan00]

Did Christopher Walken dub this?

[@jsweezey6487]

Are all popcorn ceilings toxic & contain asbestos? If so how do you repair the pealing/crumbling? Do you need to wear a respirator goggles etc.?

[@Docsscalemodels]

Depends on the year it was done. Pre 1980s have it checked.

[@RibeyeSusie]

Great vid! What do you think about the Homax Pro grade white popcorn, ceiling, texture spray for a small spot to use by a homeowner?

[@cjbarlow61]

The 13lb dry mix box is great for small repairs or a single room. Buy an 8 gallon compressor, a spray hopper, and mix it up following the directions on the box, and spray it. Lowes sells 40 pound bags of dry mix that's a better deal than the homax blue boxes, which i think may be discontinued soon

[@samuelvigil3604]

I do these repairs all the time and the steps to repair and the cost is right on. But didnt see your finished results.

[@sharonrichards3442]

What was that all about still did not see the finished job waiting to see the surface primed and the texture go on and the stippling finished

[@jamesgonte8216]

Do you work in Sebring, Florida ??

[@BrianOminous]

Does no one else hear Christopher Walken when this guy talks - because I do.

[@theropesofrenovation]

I knew it sounded familiar. lol

[@charronfamilyconnect]

What kind of primer do you use? I see many videos showing people putting an all purpose joint compound down and then the textured ceiling material? Is this joint compound considered a primer? Could I use a flat ceiling paint that contains paint and primer as my main primer?

[@spencercolgan]

I love your question. Technically speaking, you do not need a primer but, take a look what happens when you don’t use one. The compound in the texture it doesn’t stick, does it? The proof is in the video. If it were my property, I would use a primer and yes, you are correct, your ceiling paint will suffice

[@charronfamilyconnect]

@@spencercolgan Thanks for the quick reply! I have a very small area of popcorn that fell off from water damage. I want to scrape off the lose area(smaller than 1 sq foot), and put the same ceiling paint that has primer in it down. Then when its dry I will put some all purpose joint compound down in 2 or 3 coats, and then put the textured popcorn material down & paint with this same paint. I am debating to use the homax aerosol popcorn solution since its a small area or should I buy one of those crow feet brushes to match up the joint compound to the rest of the ceiling before painting it?

[@spencercolgan]

B Charron I have to tell you the honest truth. If you’ve never done this before, and if you really wanted to look nice… Scrape it all off and re-popcorn your ceiling but if you don’t want to do that, start in the middle of your repair and work to about 1 1/2 feet outside of the repair area just beyond the fixed… And do what’s called feathering… It’s not that easy to do so if you have a little finesse in your bones, I think you could do it

[@charronfamilyconnect]

When you say feathering, do you mean to use one of those crows feet texture brushes? I guess you are no fan of the Homax Texture ceiling spray? Thanks!

[@spencercolgan]

B Charron I mean go from thick to thin in a progressively thinning application stroke.

[@samuelfloyd5072]

It pulls away easily because it got wet and it’s integrity was compromised not because it was not primed. I have never seen a preprimed popcorn.

[@spencercolgan]

Would you not agree that it would not pull away if it had been primed underneath? In other words, if the sheet rock were sealed, do you think that popcorn would have pulled away so easily?

[@samuelfloyd5072]

I personally think that it might not be a good idea to make it stick the best possible, in as much as most people are getting rid of popcorn. I don’t know if it’s better but I can certainly say if there is a watermark you must pre prime so the popcorn is not discolored.

[@teprice2000]

If it were primed it would not pull away. The primer creates a surface for paint or texture to bind to.

[@ReginaBarnett]

What kind of binder? I have this problem.

[@spencercolgan]

One with polymers.

[@sinister2055]

Use peel stop or an oil primer like zinsser. It will stop the peel.

[@spencercolgan]

Correct!!!!

[@Lefishn]

What about smooth plaster where popcorn peeled? You use Zinser or a bonding agent like you would for concrete so that the popcorn adhered to smooth surface?

[@johnbrain8408]

The industry standard practice was never to prime sheetrock before spraying simulated acoustic aka popcorn.

[@ThatKiltedGuyDIY]

My dad and I were spraying this stuff in the 70s, and you are correct. We never ever sprayed over primer, although there were some times we rolled drywall mud on as a white wash just so none of the paper ever showed through since they weren’t painting them. The acoustical ceiling texture will stick to the drywall paper just fine.

[@noahbodie3075]

He's got a Christopher Walken thing going.

[@a.r.774]

You make it sound harder than it is and knocking house flippers. Not ALL house flippers do bad work, I've seen contractor jobs that would make you cringe, I know this because I'm a house flipper from California

[@spencercolgan]

You sound like a good one pal. No harm intended.

[@colettejaques2559]

Cut it out 😂😂 Most flippers don't know what there doing...this guy knows his craft. What a joke 😂 look at what the flipper left..😮😂

[@johnhowell8204]

This guy's a dork, he doesn't know if a flipped did it, he said it was probably a flipper. He sounds like tampon tim.​@@colettejaques2559

[@rayrivera5103]

Can u actually show how its done?

[@davedammitt7691]

The repair part was fine. The complaining about how the original installer didn't prime was silly. I've witnessed dozens of popcorn ceiling removals, (I flip houses, but have a knockdown guy do the ceilings) and I have never seen one that was primed.

[@JustToo_Ob]

I have peeled popcorn ceilings from my own and flipped homes and retextured with knockdown , And have never seen primer or traces of and primer under the texture and all were built in the early 1970's which show how long the texture lasted.

[@robparksusa8048]

The video presenter is exhibiting a "union" or socialist type mentality. I totally agree primer is never present...

[@ChristopherLeskanic]

House flippers are all about the most money return with the lowest amount of repairs cost..... i would be very careful and cautious before considering purchasing a house flip..... Its about quantity when it comes to house flipping, NOT QUALITY!!

[@bigern6992]

you sound exactly like Christopher Walken.

[@antonydean8063]

Test a small sample first for asbestos. Wear a 100% grade face mask. If positive you have a very expensive job to do😎

[@sherifkaissi4109]

I’ve worked on a house like that and the texture peeled like a banana eel. Ended up retexturing the whole roof

[@spencercolgan]

Excellent, excellent point and the same thing happened to me 20 years or more ago. I was very careful not to let it happen here

[@houndsofvalor]

Complain, complain, complain. Just fix the damn ceiling!

[@spencercolgan]

Lol.

[@janjuag]

I felt same.

[@bantirob]

I didn't finish the video. You spent too much time on why and how and repeated it because you felt it needed emphasis. KZbin can be replayed easily. You don't have to repeat or emphasize anything. Just want basics on what I need to do. Never got that with you. And, you don't need a part II... A for effort. But too time consuming without getting answers I need to do it.

[@shanesmith4087]

Thanks for the advice and not showing how to fix it

[@myronperish7551]

Dude show the ceiling NOT UR FACE

[@claypreddy4537]

Good advice, took way too long to get to the point. You could’ve said the same thing in a couple minutes man

[@spencercolgan]

I agree. I just started out in this video. Sorry pal.

[@brandonalger7957]

Good lord, less talk more action…

[@ballinonabudgetacademy]

This is basic information. Maybe useful for a new DIYer

[@notmypresident4066]

10 minutes of talking, no primer demo, no popcorn patch demo. Fail.

[@FirstNameLastName-mz6ri]

President? Joe Biden. Hotel? Trivago

[@nrs4866]

Thank you. I have asbestosis now.

[@osrsfonzie1897]

20K Views, only 1 comment about this. don't do this people most of these older popcorn ceilings contain asbestos unless you don't like the taste of fresh air in your lungs.

[@davedammitt7691]

@@osrsfonzie1897 actually, very very few popcorn ceilings have asbestos. Popcorn is from the 80s and 90s, maybe late 70s. Asbestos was pretty much gone by then.

[@asmodeus1274]

@@davedammitt7691 Any popcorn ceilings done before 1979 could very well have an asbestos binder in them.

[@K31swiss]

When I did electrical I wouldn’t work for flippers. They didn’t care about quality or code, just cheap, which ain’t my game. No way I’d buy a house that had been flipped.

[@johnhowell8204]

If you were more capable you would be able to access the work done to the house over the years by diy homeowners, by contractors , house flippers, etc, and maybe save some money. Then you buy a house that wasn't flipped and end up with crapola you were trying to avoid.

[@billnumby1080]

Scrap it, like you have a pair.

[@robparksusa8048]

being that you want to do things right, I am sure you hired an independent third party to test for the presence of asbestos? That is doing it right. where is the containment? If you did under the "best practices" that would be the right thing to mention. It is really simple just like with dealing with a leak from above, dry out (de-humidify) cut away to solid material, quick bonding agent (concrete variant works fine) feather over a little, apply texture (that example USG coarse is perfect. knife apply and sponge to match. Cheap labor, union type mentality, socialist rants are not needed. You should do house flipping, with the right purchase price there is meat on the bone still. (and it is pure capitalism--still) lol

[@curmudgeonextraordinaire1884]

Take it all off!

[@victoriasmith4660]

Omg stop talking and just do it.

[@normrodriguez9306]

Watch this video to listen to ten minutes of complaining

[@robertgatien2543]

It's unfortunately that you spent half of the video criticizing other people. Not very professional on your part.

[@spencercolgan]

I agree. I get a lot of bad press from this video. I had a loud mouth worker in the background who was pressing my patience.

[@dragracer4775]

Too much talk and and not enough action.

[@729888]

Quit talking. Do!