Step By Step Guide to Installing Caster Camber Plates on Your Fox Body

In todays video I give you a step by step guide to installing caster camber plates on your fox body mustang. I go over every single step so it can be a breeze when you install them on your fox body! Installing these caster camber plates is a breeze and you should have them on in no time at all!!
Products I use
VR1 20w-50
amzn.to/3t74hGD
Evil Energy Catch Can
amzn.to/3Il7zux
Dynomax Ultra Flo SS
Offset/offset 2.5 inch
amzn.to/3gbYg49
DEI Heat wrap
amzn.to/3KGnbdk
Instagram
/ iamchazhaynes
TikTok
www.tiktok.com/@iamchazhaynes...
Discord
/ discord
PLEASE LIKE , SUBSCRIBE, AND COMMENT !
THANKS FOR WATCHING AND THE SUPPORT!!!
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting iAmChazHaynes so I can continue to provide you with free content each week!

[@israelnieves2817]

Great and helpful video. I just received my Maximum Motorsports Catser Camber plates . Now ready to install after this video.

[@dntlss]

Great video man as usual,I gotta do this to my 91,any issue with the hood? thank you for your time!

[@timweb1510]

Good work man

[@iamchazhaynes7074]

Thanks man!! I really appreciate it! My wideband sensor just died so I decided to do this hahaha

[@timweb1510]

@@iamchazhaynes7074 sadly that happens far too often. Happened on a brand new Bosch sensor for me. I was pissed. With the holley, I paid extra for the NTK

[@iamchazhaynes7074]

Same here! That sensor only has 1000 miles on it!! It’s brand new it should not be going out! I was pissed to it got stuck at 15.8 my car went into limp mode scared me to death !!!

[@timweb1510]

@@iamchazhaynes7074 I’m sorry man

[@89gtsmoke]

How's the ride with the Stock Shock and the MM Caster/ Camber plate setup? Also Where did you get you hood blanket? Thanks for the video instructions - we'll done sir

[@lanny222]

So you don’t re use the old strut bushings fromStock?

[@brianmcguinn7903]

Love the intake setup. What lower intake is that

[@iamchazhaynes7074]

Thanks dude! It’s an edelbrock victor jr EFI it’s makes good power in the top end let’s the turbo EAT lol