stihl ms192tc carburetor adjustment

[@tmarinelic]

Thanks. Could you do a tuning on Walbros with no screws?

[@Rusty_ok]

Good information. A friend just gave me this chain saw because he could not get it to run. I will use your tutorial and see if I can make it run.

[@smallengineguys]

Great saw. Make sure to drain gas and put in fresh bought today gas.

[@Rusty_ok]

@@smallengineguys used your video and advice & drained gas. Spark plug was gapped way to much so adjusted to what the book said 0.020. Took out the plugged spark arrestor screen and cleaned out the black carbon. Looks like to previous owner used to much oil in the gas. Starts on the 3-4 pull now. Runs like a striped ass ape.

[@smallengineguys]

@@Rusty_ok perfect!

[@ronaldduffield6237]

These videos really help thanks alot

[@smallengineguys]

Glad you like them!

[@fixtritephil7712]

Ideally Slightly less than full RPM's.open the high an 1/8 turn more than full RPM' or slightly richer to prevent lean over rev and possible seizure...

[@smallengineguys]

at over rev it would be to lean under load and bog. so you would have to enrichen it. also ill run it lean screaming it would take gallons of gas at full rev never any load to damage it if it ever did in the first place. I'm going to have to do a video to show people this so every time i get one of these comments i could just send a link.

[@TheCycleProf]

thank you. bogging to perfect in minutes nice job on this.

[@smallengineguys]

Glad it helped!

[@sambeasley893]

Ms 194t runs only on choke. Any ideas where to start?

[@smallengineguys]

there are 2 carb adjustment screws. you need to turn the one closest to the air filter counter clockwise 1/4 turn at a time till it runs properly

[@sambeasley893]

@@smallengineguys thanx much. Enjoy your channel.

[@jefferia8]

Very good

[@smallengineguys]

Thanks.

[@leandropija2046]

👏👏👏👍