supmix chainsaw air filter fix, the cheap and bulletproof way

[@j_k_s2357]

You can add an oiled air filter sponge into the shell of the crappy air filter. You will have to adjust the high and low idle screws though.

[@Berta_5.sl0w]

Good I love a Canadian on a rant lol

[@Cherokee-sz7xi]

Ok so in your experience,, who has the best Chinese saw? Thanks

[@chainsawcanuck]

The zenoah clones are all the same, just different plastic, best plastics so far go to proyama . But their 62cc is only 49.5cc, the supmix is the best bang for your buck at 54.5cc,(advertised as 62) but all these saws need to be gone through

[@jjm3254]

Not bad for the price.

[@dusty1498]

Did you say the plastics are better quality on the orange supmix then the red one? Notice the orange model is always 30 bucks More!

[@chainsawcanuck]

Yeah quite a bit better

[@dusty1498]

@@chainsawcanuck Thanks, I will have to watch for it to come on sale!

[@Indeewoods]

Just go to “F#%^’n town 😂😂😂😂😂

[@scottfoster2487]

Gullabable consumer marketing by the off bredd manufactures is hillarios.

[@chainsawcanuck]

Yeah it's funny I've seen these marketed as high as 78cc.. Lol but really thay are not bad saws.. Better value than husqvarna home owner saws imho

[@crazyfeller5704]

Lol. I assumed they must cc the cylinders to get away with that. I picked up a neotec ncs6200. They advertise as 60 cc. 34mm stroke and 46 mm piston. 56.5 cc No loctite required, every piece of plastic has to be wedged, pulled and finessed to get it to start screws. I have foam rubber sheets that I used to seal it up. I tried motoseal as well- came off the seam. Ended up sanding the surface and using epoxy. As soon as I get the muffler outlets opened a bit- I will try to get it in the wood and see how it does. Compression is surprisingly high with .030 squish. Overall it’s ok, considering i got a 50 cc saw and a bar and chain for $126 delivered, cannot complain too much.

[@chainsawcanuck]

@@crazyfeller5704 have heard of people using o-rings to seal up as well, i like the black rtv because it doesn't stick well to the base and basically just makes a rubber gasket

[@chainsawcanuck]

@@crazyfeller5704 boedy bought that wemars that's measure out to 60cc. It must have the 48mm cylinder I keep seeing on ebay

[@crazyfeller5704]

When I measure mine from the exhaust port, I got 47…..so….until he pops the cylinder, I would be suspect.

[@sigma_kappa]

wrong filter dude so now not screwed down

[@chainsawcanuck]

It's the filer they supply, all these submix saws suck fines because of poor filter setups