Swapping out front axle shaft AAM 9.25 dodge ram

[@ZiggyWolf.4.0]

Comment not connected to this video. Was waiting for a new video and saw that I was not subscribed anymore. No likes,no comments, no questions....all gone. 🙄 . You gave me good advice from beginning this channel and this sucks. My both repair shops goofed up and I can't find the info on my 03. Put it in storage until I find a knowledgeable Ram service, or get another truck. You've done good content. Keep it up. Z. 🇮🇸 . As always, 2👍's up.

[@DirectCurrent4u]

That looked like a real struggle for sure! I hope the other side does a lot better for you. Lots of Anti-seize on the splines will help next time you have to pull that bearing off. At least your bearing was not seized in the knuckle like most of them are. Nice video. keep up the good work.👍

[@spencersgarage]

Yeah buddy. Just finished a complete front suspension rebuild on my ‘03 2WD. Damn these trucks are a struggle to work on! 👍🏼

[@LoneWolf-cf5tp]

I literally just changed the front axle shaft u joint on my 06 two weeks ago. I’ve never had the splines bind in a wheel bearing before though. Sorry that happened to you. Also I always polish those splines before I install the shaft into the axle with a brass wire wheel. Usually helps with the install. Good job though 👍🏻

[@OutpostCTD]

Thanks for the wire wheel idea I may try that before I do the other side

[@fitdadjourney]

Both by ABS sensors went on the front, I was considering doing bearings at the same time. This should be interesting. I have an 03 with 329k on the ODO.

[@maxdeal1856]

Do these have seals too because I have the same truck with 4wd and the u joint is leaking diff fluid I believe