Swift Craft | Electronics phase 1 | 3D printed quadcopter
Рет қаралды 1,532
Күн бұрын
@Devsaxena922 2 ай бұрын
Great design 🔥
@NoobFPVPilot 2 ай бұрын
Thanks 🔥
@PartyHat-m3c Ай бұрын
it looks so amazing🔥
@NoobFPVPilot Ай бұрын
@@PartyHat-m3c Thank you so much! 🙌
@rckyfpv Ай бұрын
1in4 esc and sbus reveiver would be much better, but still good job
@NoobFPVPilot Ай бұрын
@@rckyfpv Thanks mate! I didn't have a 4-in-1 ESC and an Sbus receiver when I started out in the hobby so I made do with what I had 😅✌️
@leaoaugusto Ай бұрын
1 minute flight time?!
@NoobFPVPilot Ай бұрын
@@leaoaugusto LOL that's what I thought too but it flew for 3 minutes outdoors on a 1000 mAh 30C 3s LiPo... This means that all the four motors combined pulled a maximum of 20 amps only!
@leaoaugusto Ай бұрын
@@NoobFPVPilot 3 minutes, not bad. I assume this is the first iteration of this quad, and you will make it much better in the future. great job man!
Surya Krishnakumar
Рет қаралды 3,9 М.