Diagnosing binding problem on Trex 250 Tail assembly Part1
Пікірлер: 14
@ROBRENZ13 жыл бұрын
@laoch33 No. You are turning the inner pitch slider bushing clockwise. It is threaded into the pitch arm. When you tighten it, it moves further into the pitch arm, squeezing the inner races of the pitch slider bearings together which reduces thier clearance.
@ROBRENZ13 жыл бұрын
@laoch33 The inner bushing is threaded into the pitch arm. Tightening it a little pushes teh inner races of the bearings together reducing the play. Make sure you have the tail shaft in the bushing when you try to tighten it. You can crush that inner bushing in a heartbeat.
@ROBRENZ15 жыл бұрын
That is what a machinists hands look like
@laoch3313 жыл бұрын
@ROBRENZ ahh ok. Thanks! I only found these vids last night along with the chinese mod. I'm a mechanical engineer myself, college done but no work yet haha. But it's really nice to see some drawings like that in the vids :D Just to make sure I've got this right: I should put the pitch slider on the tail shaft, then squeeze it with a flat pliers in the axial direction gently, all the way round, in order to push that slider bushing radially outward , to get th inner races to squeeze together,
@mikegigabyte14 жыл бұрын
Just noticed mine was binding big time, and I thought it was smooth when moving the servo by hand, but pushing the rod by hand it was very sticky Ive just built the 250 and have a slight wag, more in flight then in hover. Hopefully this will help get rid of that. On mine all I had to do was loosen the screws on the black plastic parts to make it slick and smooth. I had tightened them way to tight before. Didnt know any better
@mikegigabyte14 жыл бұрын
Yes it was the plastic fingers were to tight, my problems have gone away now. I even flew in the wind, perfect
@ROBRENZ13 жыл бұрын
@laoch33 I do have chinese weights for the 450
@laoch3313 жыл бұрын
@ROBRENZ Oh! Nice, that sounds neater and easier :). Did u ever make a kit for 450 size?
@laoch3313 жыл бұрын
how did you tighten up the slop in the slider bearing, I didn't understand that bit- Did u just squeeze each end axially together with a pliers?
@aecrim196915 жыл бұрын
Dude, clean your nails!!!!!
@bagariddim9429 жыл бұрын
My god mate when last did you clean your finger nails honestly good video but disgusted by your personal health!
@ROBRENZ9 жыл бұрын
+Bagariddim I work in a machine shop on cast iron. It makes your hand dirty just like a car mechanic working on a dirty engine. I do these videos during the day while I am working. Then I wash my hands and quit for the day. My personal health is just fine.
@BubbaB437 жыл бұрын
Bagariddim some MEN actually do manual labor with their hands! His hands are stained like that just like mine!