TAC-41 - Right/Left conversion

[@DOConnell333]

My bolt lug is not budging its stuck. In the video at 00:18 it seems it should just slide out? I have a TAC-41 LS i assume the procedure is the same. Any advice i dont want to use excessive force the gun is brand new. Edit: to answe my own question no the LS is different. There is a pin in the bolt lug which you cant pull out so you must knock it in - down towards the trigger. To push the pin back in its easiest to remove receiver from the chassis and push the pin back once you turn the bolt lug around. There are other differences too such as the trigger box being attached with C clips instead of hex bolts but thats not relecant to this issue. Here is a more useful video specific to the TAC 41 LS. kzbin.info/www/bejne/gKbLeWejiM2hjJosi=NUKYZzzl4TumX2ys

[@TheJonathankang]

Didn't expect to hear FTL soundtrack here, haha

[@elviodegrandis6647]

always the top

[@jimfowler4924]

There’s no M4x6 set screw in the one I’ve received - have they changed the bolt please? Can I just undo the end bolt? There’s no hole in the side of the end cap!

[@jimfowler4924]

Silverback have confirmed, "There is no set screw on the aluminum Bolt, so the bold end cap screw is secured by thread lock fluid, if the bolt cap screw is difficult to remove, put the full bolt back in the receiver, with the spring guide stopper, then unscrew the bolt end cap screw. Being in the receiver, it won’t be able to rotate freely, you might need to apply some force , but it won’t damage the components."

[@foxcharlieromeo9071]

Nice 👍

[@ernstmeijer3067]

Some more news on release off this Masterpiece when in stores?

[@szelmen]

1:11 i think this is M6x4 rather than M4x6, I lost mine and watched that video. Purchased M4x6 and it is way too small. Can you update on this one, please? Thank you. I love my TAC-41 :)

[@szelmen]

It is M6x6 just fitted mine in.

[@73kriss15]

👍🏻

[@blwatches2260]

Hey what's the point of the 19 bbs feeding ramp? Can you shoot these bbs when the mag is empty?

[@ROGUESPIRIT_]

if you point the gun to the fl,oor it is possible, its main purpose is to allow the magazine to sit in the correct location instead of too far forward.

[@rogerborg]

It's just to reposition the magazine. But filling the feed ramp is a one-time operation (unless you change BB weights). It's neither a feature nor an issue in practice.

[@The_Mexecutioner]

When?

[@ernstmeijer3067]

Take my money please