Tahoe Yukon Suburban Rear Window Regulator & Motor Replacement (2007-2013)

In this video I show the steps and procedures necessary to replace a rear window regulator and motor assembly in a Chevy Tahoe, Chevy suburban, GMC Yukon, or Cadillac Escalade, years 2007 through 2013. The particular vehicle I’m working on today is a 2007 Chevy Tahoe with about 151,000 miles on it. And in my case I can hear the window motor turning however the window does not move up and down which is a good indication that your window regulator is bad and needs to be replaced. Below are linksIn the description so you can find the correct part for your application. Keep in mind that larger SUVs like the Yukon XL Chevy suburban or Cadillac Escalade ESV, require a different part number than the smaller SUVs like the Chevy Tahoe, GMC Yukon, or Cadillac Escalade models. If you have any questions or comments feel free to leave something in the comment section. Thank you for watching
PARTS USED IN THIS VIDEO:
2007-2013 tahoe, suburban, yukon, yukon xl, escalade, escalade esv (front driver)
amzn.to/2PX3pji
2007-2013 tahoe, suburban, yukon, yukon xl, escalade, escalade esv (front passanger)
amzn.to/2YYXpKW
2007-2013 yukon xl, suburban, escalade esv (rear driver)
amzn.to/2rOmigh
2007-2013 yukon xl, suburban, escalade esv (rear passanger)
amzn.to/2S8vsii
2007-2013 yukon, tahoe, ascalade (rear driver)
amzn.to/34vtGKx
2007-2013 yukon, tahoe, ascalade (rear passanger)
amzn.to/2M5ts6A
TOOLS USED IN THIS VIDEO:
Trim removal tool set:
amzn.to/38PUsAM
Needle nose pliers:
amzn.to/2S4rN56
Milwaukee M12 FUEL 3/8" Ratchet Auto Kit
amzn.to/38Ut8kL
If you have found this video helpful, and you wish to donate to me, follow this link!! its easy!!
paypal.me/aaronhinesauto?loca...
Follow this channel on twitter for the latest content updates and weekly Automotive Tips!!
AutoHines?lang=en

[@thegardenoflife8397]

Thanks man $60 fix instead of $250+ service done 👍🏻

[@orlandotoussaint6851]

You’re a lifesaver. I live in a cold climate with young children, so to fix my truck by using your tutorial is truly a blessing. Thank you!!!

[@gwarfield818]

Extremely helpful. Everything at home worked just as easy as in the video. If anyone doesn't already have the pry tool you can use a thick/stiff putty knife to pop out the plastic clips and a thin flat blade screwdriver to take off the small cover and the door lock button.

[@chisel291]

One of the best step-by-step videos I’ve seen on KZbin yet, you guys rock

[@vmarr0y0]

7 minute video, took me about twice as long following along. Thanks

[@ismaelbonal6537]

Thanks a lot for this video. The left rear window of my 2013 Tahoe came down and sure enough, it was a broken regulator. I followed the instructions in your video and replaced it today and now it's back working like a charm. A very helpful and detailed video indeed.

[@aG-lc6su]

Where did you buy the regulator

[@ismaelbonal6537]

@@aG-lc6su You can get online on eBay. You can buy an OEM part not necessarily the original. Just make sure it meets the specific part number or the specific car model. You can always message the seller to make sure before ordering. I live in Qatar and there is a seller in the industrial area specialized in OEM parts for American cars.

[@amalroshan6563]

@@ismaelbonal6537 how much did you buy the regulator for, I live in Oman

[@ismaelbonal6537]

@@amalroshan6563 Here in Doha it cost me around 250 QAR which is around 25 Omani Royals (I think).

[@amalroshan6563]

@@ismaelbonal6537 thanks a lot sir, Did you do the work by yourself ?

[@geraldcueto6689]

Thank you for this video, just had to do the wife's Tahoe and we have an infant so you can image the look I got. Thanks again

[@sonidoxxkandalo]

Thank you 🙏 I replace mine today watching this video

[@beegee22]

Great step by step video! A couple of minor details - on my Yukon (short wheel base not the XL) there is only one bolt under the door pull at the middle of the door, and pulling the door panel from the door was nowhere near as easy as it looks in the video- it took a lot of prying, sliding around the edge with a trim tool and pulling to get it to pop off. Once it was apart getting things back in place was quite easy. (A note to the absent minded like me, it helps to reconnect the power harness to the window motor - testing before buttoning everything up was helpful. I had to come back to the video to see if I missed anything. I had only plugged in the harness to the switch. Duh,) On a humorous note it was not until today after many attempts to get this rear window to go down all the way that I realized that on the short wheelbase Yukon it only goes down about halfway because of the wheel well cutout in the door. I've only had the car for 3 1/2 years. 🙄

[@fermainjackson2899]

Very useful and informative your video dude. I liked it. My case is in the right door.

[@andygunter590]

Great instructions. Turn up the audio for us old goats that don't hear so well. Thank you!

[@ffitz78230]

Thank you for the clear and complete instructions. Like the others, the drivers side rear window came down with a bang, the motor turns but the cable popped out of the regulator. I'm guessing if I managed to reassemble it, it would only pop out again.

[@Zav690]

Bro. Thank you so much for this. A few days ago I closed my rear door and the window just dropped. Im about to apply this method.

[@caution_xray]

This video was very helpful.!! Thanks 🤙🏽💯

[@brianyount2629]

Great video! Saved me a trip to a shop!!

[@thescorpion011]

Nice video, really helped me 👍

[@elishaduncan2479]

Great review mane keep up the good work. I got the same problem thank for the video.

[@JohnnysSpeedShop]

Good stuff mate.....cheers Johnny.....

[@AaronHinesAuto]

Thank you bud!!

[@dagolopezsr2004]

👍🏽from Rancho Cucamonga CA , well explained❤

[@danabrownprivaledge]

Sick ass video bro your a life saver

[@antoniomccurry6047]

Awesome! Thanks

[@mustronggaraje]

Buen video me ayudó mucho gracias

[@juangalicia8662]

Thanks you Sir

[@dagolopezsr2004]

👍🏽buen video 🤜🏽

[@andrewzalewa4429]

Thanks

[@ShaneChristopher]

Great video…but you you might want to add how to detached the window switch from the connector. I had to look up another video so I didn’t break it…but I’m an idiot. Thanks

[@bypass04a]

Great video. Thanks. QUESTION: CAN THE WINDOW BE ADJUSTED IF it WORKS? Mine will move up and down, but will not close completely.

[@ffitz78230]

I would guess you have one of 3 problems. 1. obstruction in the track... if this is the case you must find and clear the obstruction because a new motor/regulator would have the same problem. 2. regulator slide assembly is not holding the window correctly... window is mis-aligned where clamped. 3. The the cable around the pulley on the end of the motor has jumped across to an incorrect position. Chances are it will do it again. Replace assembly recommended.

[@alexochoa1176]

My windows go up and down properly. The issue I'm having is my windows rattle when I'm driving over bumps and they're partially rolled down. Any suggestions? Thx

[@crashgorilla]

Easy enough

[@prometir]

Hey but I plugged in the new window motor for the test and it doesn’t work either

[@CAcertifiedboogeyman]

What if I don’t hear the motor?

[@mattb6001]

The plastic broke on my 2008 window regulator. What a shame the whole thing has to be replaced because of this. i.imgur.com/Hd926WT.jpg Also, anyone got any torque specs on any of these bolts?

[@beegee22]

Looked at your photo - mine was broken in exactly the same place.

[@SantanaDippin]

The wheels clean I like them but ..that truck ugly as hell

[@oj831]

Thanks life saver 🫡