The original output release Valve O-ring came from the factory is loose. This tape explains how to replace it. I hope you enjoy this tape. Thanks for watch
Пікірлер: 10
@BB2K-Airsoft4 жыл бұрын
Nice Airsoft! i search it for a long time. thx for the video
@porgws4 жыл бұрын
Welcome and thanks for watch... ^^
@shadowjohntube Жыл бұрын
8:22 o-ring 4mm x 2mm or 3.8mm x 1.9mm(origin) gets stuck after a few uses... I suggest you use NBR 3mm x 2mm replacement. 3x2 works fine
@porgws Жыл бұрын
I've tried the size you suggested before. But still have the same problem. I've tried going up and down several times. For this Target FS-0317, the problem disappeared. Until today, it still works normally and without any problems. If in the future the same problem arises, I will try changing the size as you suggested. Thank you very much for your advice.
@kaluleku2321 Жыл бұрын
華山猛槍
@MrFreefonix4206 ай бұрын
Mine still gushes out has from the top of the system, any ideas? I raplaced all the seals
@porgws6 ай бұрын
from experience I would like you to consider changing to a different one or making the O-ring size slightly larger (last option) because I have compared it with a cylinder. I feel like there is very little difference in size but it does have an effect on gas leaks.
@MrFreefonix420 Жыл бұрын
Can these use red and black gas for extra punch?
@porgws Жыл бұрын
Personally, I recommend using a normal pressurized gas canister. Increase the service life for a longer time.
@MrFreefonix4206 ай бұрын
@@porgwsI replaced all the seals as shown here but mine is still leaking.