Multi cycle path in VLSI | Multi cycle path Constraint | Multi cycle path example

[@nithishm4493]

Hi Team VLSI, can you do one video on Half Cycle Path?

[@nagarajunaani5004]

Nice Arun ... Keep continue this series on short topics ... Thanks

[@TeamVLSI]

Sure 👍

[@ArunKumar-wu4px]

Nice presentation

[@TeamVLSI]

Thanks a lot Arun. Keep supporting!

[@mekalagowthami162]

Sir.. can you tell... How we will get know about MCP. Is there any command to check what are the MCP in our design..(consider we didn't set MCP in sdc fie)

[@sonikumari-xf4ls]

Why setup check is done at next clock edge and hold at the same edge?

[@amrutagulgond2265]

Setup always affects the capture flop and hold affects the launch flop

[@darbylarson8800]

Hold constraint is basically trying to prevent a race condition so that a fast data doesn't accidentally pass through to the capture flop at the same clock edge, so hold check is only relative to a clock edge. Setup constraint is trying to prevent a scenario where data moves so slowly that it doesn't get to the capture flop even before the NEXT clock edge, so it needs to take the entire clock cycle into consideration.

[@omkarrasal9224]

As you said after applying MCP for setup after 4 clk cycles ,hold will be checked at before that clk cycle But hold will be checked at same Clk edge and that are both different edges pls clarify my doubt

[@TeamVLSI]

time stamp please.

[@KavitaSharma-wm7wq]

can you please check once where will use -start and -end switch? I think in slow to fast we use -end switch and in fast to slow clock we use -start switch....please let me know also if I am wrong

[@TeamVLSI]

Thanks, Kavita. You are right. The way you are saying will always shift the check edge with respect to the shorter clock period, Which is absolutely right. But I don't think it is a necessary condition.

[@viralvideosfull]

If I have a hold violation of 100ps how much setup slack I need.

[@TeamVLSI]

Hi Aneel, Generally 2 to 3 times depending on library.

[@viralvideosfull]

@@TeamVLSIHI could you please make a video on why do we need virtual clocks

[@mytravelstories8587]

sir you have written start in the command and making changes in the end clock in the final example please check it. If i am wrong let me know

[@omkarrasal9224]

While writing for MCP for hold you told 3 that Is (n-1) and in note you are telling applying MCP for setup hold gets affected by same no of cycles in Same direction pls correct me if I am wrong

[@TeamVLSI]

time stamp pls of video.

[@arunsahni3940]

@@TeamVLSI at 15:23

[@ArunKumar-wu4px]

How multicycle will help to fix hold time

[@TeamVLSI]

Hi Arun, It wont help.

[@saijagadeesh1708]

Why hold is reverting back after applying MCP?

[@TeamVLSI]

Hi Jagdeesh, Because we want to provide MCP only for setup.

[@arjunnatukula7128]

grt work

[@TeamVLSI]

Thanks Arjun. Keep learning keep supporting...

[@arjunnatukula7128]

@@TeamVLSI bro..can u do for rtl.spec..like coding constraint, linting

[@anithasabhavat6064]

How to identify multi cycle paths in design?

[@TeamVLSI]

It is an exception, you can check the SDC file.

[@debmallik]

@@TeamVLSI If it is not there in SDC and then how to identify violation is true or false due to multicycle

[@suprajithhs5609]

Check for flip flops which are driven by clocks of different frequencies.