TECH TIP: Mahlkönig E80 Deep Clean

[@georgerobertson35]

Great Vid.... Didnt need to clean or even knew it existed for the first couple of months, now it needs cleaning twice a week...

[@baristapassion]

Satisfied video 😍

[@StacksEspresso]

I see someone is a classical guitarist!

[@orionstrongman2656]

Perfect video bro. Many thanks

[@georgerobertson35]

Hi, You insert the metal upgrade on the inside of the silicone, but on other videos I have seen it inserted on the outside, please can you advise which it is supposed to be?

[@JimTMcDaniels1]

Silicone goes forward/outside of the metal flapper! Take care

[@Brett-p1z]

Have you ever had the bolt that is holding the bottom burr carrier completely stuck from factory? Have not been able to release it, have used lubricant, correct sized scewdriver and given it everything.

[@eugenewilson6547]

I have this same issues. Even while using correct tools, screwdriver and natural heavenly given strength, feet in position and twisting with my core to provide maximum torque….i have unsuccessfully been able to remove the bottom burr. 🤷🏽‍♂️

[@skaboom64]

Make sure you’re rotating counter clockwise… totally kidding. I’m about to do the same. Any alternative tools to hold the lower burr?

[@jackjack605]

What can I do if I dont have the burr changing tool?

[@GH_GBS]

You can grab one from our website. You can probably still get the job done without it, but it's alittle more difficult. The idea is you want to keep the rotating burr in place. You'd put a screwdriver through the inside of the chute. But be careful not to scratch the metal.

[@amadeochapa5553]

What type of brush did you use?

[@GH_GBS]

A brush with metal bristles

[@SweetMilkArt]

What if you can’t get the middle portion to turn

[@GH_GBS]

Try tapping it to get the stuck coffee out. If you need further assistance, feel free to reach out to us via [e-mail]

[@vikeskie]

i had this problem at first, loosen the two screws at least 2-3 turns, the hopper inlet has to drop about 3/16” to be able to turn it.