Testing Vevor's High Pressure Diving & Paintball Air Compressor - Safe?

  Рет қаралды 2,303

electronicsNmore

electronicsNmore

Күн бұрын

Пікірлер: 22
@electronicsNmore
@electronicsNmore 9 күн бұрын
ADDITIONAL SAFETY INFORMATION: Compressor must be on level ground, and the oil level(Using what I showed in the video) must not be above the center of the red bullseye when in use, otherwise you risk having small amounts of oil end up in your discharge line. If odors are still detected in the air supply, leave the large white filter in place at the inlet, but fill the entire large filter with activated carbon. My testing has shown you can fill the tank at least 3x before any moisture makes it past the white filter. The moisture beads are not really needed, replace the white filter and felt pad every 3 fills. Test breathe air from cylinder one fill and make sure no headaches or dizziness before using underwater. Stay safe!
@highrx
@highrx 6 күн бұрын
I was a SCBA tech. All the of our Breathing Air compressors had oil for lube. It was a special formulation of oil. The air went through special filters before going into the cascade bottle system. The Air had to be sampled and then sent to the lab every 6 months to be tested for contamination.
@MrAcEsNeIgHtS1188
@MrAcEsNeIgHtS1188 11 күн бұрын
Thanks for the video and info! It's always nice to get a surprise Patches cameo!
@GigsTaggart
@GigsTaggart 11 күн бұрын
You can regenerate those molecular sieve beads, just put them in a low oven for like 8 hours.
@electronicsNmore
@electronicsNmore 11 күн бұрын
Thanks for the information!
@palmerreising3387
@palmerreising3387 11 күн бұрын
Oil in the system would be a big concern for me.
@Hudsonkem
@Hudsonkem 11 күн бұрын
very interesting. I dont know who I got here but it was interesting. thanks.
@electronicsNmore
@electronicsNmore 11 күн бұрын
Thanks for watching!
@JT-lq4yd
@JT-lq4yd 11 күн бұрын
I have never gone scuba diving, but if I did, this was my worry about using compressed air and having a contaminant in the air supply.
@palmerreising3387
@palmerreising3387 11 күн бұрын
Open the cylinder and clean it out or fill and purge it upside down three + times.
@electronicsNmore
@electronicsNmore 11 күн бұрын
I actually opened the cylinder, took distilled water with a little bit of Dawn soap shook it around to clean any residue, then rinse with distilled water, then 90% alcohol inside shook it around and allowed it to drain and dry
@palmerreising3387
@palmerreising3387 11 күн бұрын
I would suggest being exceptionally leery of breathing air from that compressor even with a "food grade" oil. I suspect that even edible oil could cause grave problems if inhaled in quantities. Atomized oil, apparently coats alveoli and prevents transpiration. Do not risk your life to save 25.00.
@electronicsNmore
@electronicsNmore 11 күн бұрын
Apparently there's no atomization of the oil because if you watch the entire video, you would have seen that I discharged the entire tank and swabbed the inside of the mouthpiece zero traces of any residue
@dennisqwertyuiop
@dennisqwertyuiop 11 күн бұрын
better filter than your first vid,,,i would feel safer,,but still never a oil comp. to breath,, its your life
@electronicsNmore
@electronicsNmore 11 күн бұрын
There are many dive shops that have oil compressors
@reggiebannister1080
@reggiebannister1080 10 күн бұрын
warning do not set the bottle in water why if it does explode.. you create plastic shards as well as trippled the power of the explosion because the water does not compress leave it outside 50 feet away from anything preferably surrounded by a brick wall etc all 4 sides never walk away from it... always have a way to shut off the compressor ie pull the plug etc
@campandcook3118
@campandcook3118 8 күн бұрын
The bottle is usually tested for 4/3 of the rated pressure. 300 bar for 200 bar tanks, 400 for 300 bar tanks, even if only used for 200-250bar.
@electronicsNmore
@electronicsNmore 8 күн бұрын
Correct. Test pressure is 300 bar for the tank that I only filled to 200 bar
@NazikcAK47
@NazikcAK47 4 күн бұрын
​@@electronicsNmore bro, you're active on comments even after 14 years If you will reply I'll be happy all my day ;)
@reggiebannister1080
@reggiebannister1080 10 күн бұрын
second adcive dont use cheap chinese units use usa manfactured ones.. and always test your tanks every 5 years etc etc always replace orings per manfacture specso you send it to a shop for this for certification
@L0CXDOWN
@L0CXDOWN 9 күн бұрын
Don't worry guys, he's a weasel.
Many Moving Magnets Melting Metal
20:21
Cody'sLab
Рет қаралды 3 МЛН
Support each other🤝
00:31
ISSEI / いっせい
Рет қаралды 81 МЛН
She made herself an ear of corn from his marmalade candies🌽🌽🌽
00:38
Valja & Maxim Family
Рет қаралды 18 МЛН
IL'HAN - Qalqam | Official Music Video
03:17
Ilhan Ihsanov
Рет қаралды 700 М.
When a B-17 Tail Fell With a Gunner Inside
14:08
Yarnhub
Рет қаралды 5 МЛН
Fixing 3 Military Generators I Bought At a Government Auction
1:00:24
BradenBuildz
Рет қаралды 189 М.
OEM Chassis AC Repair Part 3
30:25
Hakuna Matata Adventure Bus
Рет қаралды 67
Turbo Fan Dusters are getting out of hand
14:08
Torque Test Channel
Рет қаралды 1,6 МЛН
I got a mail order ant colony and gave them a new home...
13:34
Homemade Ecosystems
Рет қаралды 9 МЛН
Kurtis BROKE The Big Lathe AGAIN! 😅 | Apron Gear Repair ⚙️🛠
47:38
Cutting Edge Engineering Australia
Рет қаралды 773 М.
Water your yard FOR FREE !!!
17:01
SuburbanBiology
Рет қаралды 829 М.
I built the BEST AIR ENGINE (New Rotary Design)
18:58
Integza
Рет қаралды 1,2 МЛН
Unfiltered 100% Waste Oil Vs Stock Diesel Heater
19:38
SteinFab Garage
Рет қаралды 534 М.
Extracting strontium with a microwave
35:03
Extractions&Ire
Рет қаралды 564 М.