The Trials of Sensorless Homing...

Here's a quick tip for those trying sensorless homing. If you can't get the perfect balance between too sensitive and not sensitive enough, adjust the current on your drivers and try again. Perfect homes every time!
🔔 Subscribe and ring the bell to get notified when we post a video! 🔔
🔥 Links 🔥
🛒 Webshop: www.3djake.com/
📲 Facebook: / 3djake
🔒 Facebook Community Group: / 3djake
📸 Instagram: / 3djake_official
#3djake #3djake_official #3dprint #3dprinter #fdm #filament #thejoyofprinting #thingiverse #print3dwithlove #3ddruck #3ddrucker #Impresion3D #stampa3d #3dprinted #3dart #3dprinting #sensorlesshoming

[@BlackGymkhana]

1:12 your belt rubs inside aluminum profile...

[@somathebest]

XD Too funny i love it, i know exactly how it feels because i got an ender 5 with TMC2209 too. Like From Spain!!

[@numberformat]

This video encapsulates the entire process of setting up sensor less homing pretty accurately. However it doesn't show the process of when you have everything working for a few prints then it stops working bringing you to square one again.😞

[@SgtDangerWaffles]

😂😂😂 yep try doing it with a delta for fun..... Not fun at all😂😂😂

[@wrxsubaru02]

Mine wont work if I have quick home enabled in in marlin. It will home x and y independently, but it crashes if both are homing at same time. I even set the sensitivity way up to 150 and it still fails when it is quick homing x and y at same time. How did you resolve this?

[@RealDids]

Is sensorless homing more accurate than with sensors? Or is it faster? I know it's all the buzz right now and my board supports it, but to me it just seemed like a backup solution if you don't have sensors or your sensors broke.

[@mattiazil]

It isn't as accurate as using a microswitch. the repeatability of the microswitches is around one thousandth of a mm, sensorless homing around half a mm, if I remember correctly.

[@SuperUltimateLP]

​@mattiazil that depends on your transmission ratio for the axis in question. Also repeated stalling can average out the error.

[@pedroschattanek479]

What did you do in order to change the stall sensitivity from the screen instead of the configuration_adv?

[@winandd8649]

@1:11 Look at that awful belt path! Such a design flaw does hurt my eyes 😵

[@DynoRC]

SD init fail😂