The Trick To Remove Banshee Crank Bearings

RE-DO Banshee - The Trick To Remove Banshee Crank Bearings
WARNING Don't Over Tighten These Nuts!
Subscribe 👉 bit.ly/RedoBans...
REDO-PARTS SHOP - redo-parts.com...
If you find this video helpful, make sure to drop a like & leave a comment down below!
➖➖➖➖➖➖➖➖➖
Subscribe 👉 bit.ly/RedoBans...
Extra keywords (don't pay attention):
Banshee,Race,Fun,Restore,Rebuilt,Drag,Trails,Repair,Assembly,Disassembly,Carburetor Overhaul,Turb,Redo,Redo parts,Split,Engine cases,Spliting engine cases,yamaha banshee,yamaha banshee 350,banshee

[@obedfeliciano881]

Hi cheers from Puerto Rico nice job

[@dawnhorn3949]

Hello hello!

[@fernandovitelli7423]

excelente, gracias por enseñar el proceso

[@RedoBansheeParts]

your welcome

[@jaybirdls1]

Was riding today when I heard some nasty noises, and the engine wasn’t running right. Down on power, sluggish down low, popping and cutting out in mid range. Went back to my truck to swap plugs but then it wouldn’t start at all afterwards. So I pulled the flywheel cover and kicked the starter a few times. All sorts of wobbly flywheel movements! I can move the flywheel up and down by hand 😭 I’m sure the bearing(s) are shot. Probably only 20-30 hours on this crank. I might try this to revive it!! Tempted to get a 4mil stroker kit tho too

[@RedoBansheeParts]

I would love to see some pics or a video of whats going. email to [e-mail]

[@Diebog]

My banshee has a slight growl that started after a ride, still runs fine, would it make sense to just put new crank bearings on? Or should I replace the whole crank?

[@RedoBansheeParts]

you need to inspect the crank and make a decision based on condition.

[@dennisgormley6123]

You're half way done, there's two more!

[@RedoBansheeParts]

If you have to split the Crankshaft and Replace all the bearings its not worth the time and money you should just buy a new crankshaft.

[@puch7261]

nice. i done had new cranks where the seals that go over the crank bearings in the middle rip apart and they sell the seals but no way on how to get them back on. ever run into that problem?

[@dawnhorn3949]

You must be talking about the o rings for the middle bearings? If so, you CAN replace those by very carefully stretching them over the crank web and up around the rod. They will be maybe a little loose when you first get them on the bearing but let them sit for a while and they will settle right into place. We have done this many times. If you have any questions feel free to reach out to Marty at the shop. 541 419-6054 👍👍

[@pvmcorp]

Do you have to use feeler gauge to see if its properly balanced after install or no?

[@RedoBansheeParts]

You use a dial indicator to check the crank before installation.