Raspberry Pi 3.5-Inch LCD Touchscreen: Complete Setup & Review Guide | Techeonics

[@universalgeneve8049]

For anyone trying to install this on the RPi4 on Kali linux, make sure you're using the 32 bit OS, the 64 bit OS will get stuck on bootup

[@MN-yz7bp]

very helpful! thanks

[@robibobi212]

Does this at all work with Raspberry Pi 5 8GB? Currently running 64 bit and it doesn't work, would it work with 32-bit OS?

[@D1204PrivetdriveSociety]

Good video. Please upload the hdmi comparison.

[@TECHEONICS]

On it

[@NNonameboysNN]

I have the same problem, the screen stays black and then a streak appears. I've already installed and uninstalled it countless times. and it doesn't work. any suggestions?

[@maicoul]

I'm using the 3B+ model

[@danjeloser]

Despues de tanto ensayo por fin me funciono

[@LeonardoHenrique-vf7sz]

What did you do to make it work?

[@negative1723]

i need the screen to be separate from the PI. where is the GPIO cable to connect them? is it 8 pins? i don't see any but a 40 pin cable. will that work.

[@TECHEONICS]

www.ribbon-cable.com/product/raspberry-pi-gpio-extension-cable-jumper-wires/ This will work or similar one

[@d81-r3x]

Operating system use 32 bit or 64 bit?

[@TECHEONICS]

32

[@Jeetmondal04]

Vai raspberry pi any model ko kaise kharid sakte hai

[@theonecommenter]

i get a black screen after the raspberry pi boot screen pi 3b+

[@wanmuhammadazimizzatbinche1116]

do you have any solution to your problem yet?

[@theonecommenter]

@@wanmuhammadazimizzatbinche1116 Nope, opened a support forum in there discord and everyone else was pretty amazed it didn’t work ether

[@maicoul]

the screen only shows the dash on a black screen... do I have to use the default username and password?

[@TECHEONICS]

Is this after first boot or after installing the driver ?

[@maicoul]

​ @TECHEONICS yes, after installing the driver, when call a first boot.

[@TECHEONICS]

@@maicoul CONNECT HDMI AND REINSTALL THE DRIVERS

[@mdfarman3012]

I am also facing same problem

[@ahammedmishal1622]

will this 3.5 works on rpi 5 ?

[@TECHEONICS]

Yes

[@ahammedmishal1622]

@@TECHEONICS make a video on that brother :) rpi 5 is the latest one

[@diana-xr1wk]

@@TECHEONICS i try using rpi 5 but it only turned dark and work as mouse pad only

[@appsidal]

I suggest, using the raspian os image from lcdwiki, you just need to flash it. and it works on pi5.

[@arfanmuhammedshariff3183]

​@@appsidal When I connect a display (3.5inch) it's just showing white screen for me. What should I do?

[@mdfarman3012]

Its only showing a - in black screen Please help me out of this problem

[@HezekiahZp]

same, please help