Titan Swap. What Is It and What Is It's Biggest Benefit?

CORRECTION:. I was reminded after posting the video that you can also use stock Infinity Qx80 CV shafts to achieve the extended width with the R180. This would eliminate the need to purchase aftermarket extended shafts since you could buy them from auto parts stores.

[@HardEnduro8]

I’ve broken couple R-180 half shafts. Finally dumped it and roll with M205, so much easier to swap trail side and no longer fear of axle shattering inside the diff. Good stuff with Titan swap, love mine so far

[@vagelisperrakis826]

The Titan cv's axles are stronger than frontier?

[@HardEnduro8]

@@vagelisperrakis826 yes

[@RM-ys1bn]

I ran a R180 with my VK56 swap and medium trails and a few hard ones for fun and no issues. Within a year though I went with M205 but with Pathfinder VK CVs because I wanted to keep track width and I went from a trail rig to an overlanding rig. M205 is absolutely worth it, there is even a E-locker out for it now.

[@Flying_Dollar_Motorsports]

I agree. The piece of mind is huge for me.

[@cocolandstudio]

even tho i myself have my rig titan swapped two years ago, but i really wish that this video was posted before i did my titan swap, very very imformative .. this will help a lot of people going for this project. thank you

[@onefastcyclist]

Thanks for relating your experience with a "FULL TITAN Swap" I've watched enough videos to realize that the Infinity Qx80 CV shafts were NOT designed for the riggers of wheeling with heavy tires. Your diff swap is the best solution I've seen short of the solid axle swap or buying a jeep and fixing Chrysler's design flaws

[@Flying_Dollar_Motorsports]

And Solid axle swaps are very difficult in these vehicles. There's no cheap way to do it with the way the frame is designed. You can't slap leaf springs on like you could on the older generation Xs

[@boboyamamoto]

M205s are also found in V8 Pathfinders and you can use the driveshaft from a Pathy as well, it just has to be cut and shortened which is what I did. Also if you're going to 35's make sure you get rid of the original power steering cooler and get one that's much more suitable to steer all that rubber around, you will have to cut and bubble flare the lines but it's quite easy and works much better

[@Dagrootx]

Good stuff man! Glad you could address a bunch of stuff I didn’t back in the day when I made my vid! Keep up that Nissan love!!

[@Flying_Dollar_Motorsports]

Thanks. I watched your about 10 times and stole some ideas before I made mine. Full disclosure ya know?

[@_moes_garage_]

Super informative, thanks for posting!

[@wadesafool]

What is the average cost of a titan swap done without a shop and with grabbing a junkyard m205 and junkyard titan arms?

[@Flying_Dollar_Motorsports]

Hard to say. Haven't looked at prices of M205s recently and you'd be wasting your money buying used lower control arms. They're not that expensive to buy from someone like Rockauto. Furthermore, regions can greatly affect the cost of a junkyard M205. For example, Alaska which has fewer junkyards would charge a premium and the same may go for Florida which receives higher volumes of 2WD trucks than somewhere with harsher weather like Colorado. Also, if you don't have a Pro4x or Off Road trim Xterra with an automatic transmission, you will probably have to regear your Xterra since the majority (possibly all) M205s have 3.36 or 2.94 gears and not all Xterra did

[@rizenoff-road179]

Good video! I actually run the R180 with my TS, and using the NI-8433 CV axle which you can purchase at any auto parts store. They are almost 3 inches longer than stock Xterra CV axles. I do quite a bit of rock crawling and haven't had any issues. But I also drive like like a grandma on the trails.

[@Flying_Dollar_Motorsports]

Not saying it can't be done. After all I've broken three or four titan axles too. They're just so much easier to change than R180 axles. I hope you never have to change one trailside but if you do, you'll be thinking about me now! 😁

[@Flying_Dollar_Motorsports]

Looks like you in Oregon? How far are you from the Tacoma Washington area

[@rizenoff-road179]

@@Flying_Dollar_Motorsports about 2.5 hours.

[@Flying_Dollar_Motorsports]

Sweet. I may be moving up to that area next summer. Depending on what the Army decides.

[@rizenoff-road179]

@@Flying_Dollar_Motorsports keep me updated!!!

[@Vick-yn2cy]

Great info, more of this!

[@vagelisperrakis826]

The difference between m205 with 2rib and 3 rib is huge? Does anyone has a problem with 2rib m205?

[@Flying_Dollar_Motorsports]

I don't know if anyone specifically but from what I understand, the case is just stronger. Probably won't make much difference if your not mashing the throttle every chance you get. And as long as you don't live in arctic temperatures. But I can't say for certain. I went with the 3 rib design

[@ImAFKev]

Good info, just wish your Microphone was stereo, it was very bothersome to listen to it all with my right ear

[@Flying_Dollar_Motorsports]

A couple people have told me this. But I can't reproduce the problem. It works on my computer and I tried it at work and on a friends computer and it seems to work ok. I don't know how to fix it.

[@ImAFKev]

@@Flying_Dollar_Motorsports thats unfortunate, might be something with the upload and how youtube did it

[@joshyddog2054]

This is good info! Looking on info on doing the titan swap, because I want to run a front locker, just wasn't sure how strong it will last. Where is best place to start looking for a m205?

[@Flying_Dollar_Motorsports]

Thanks for watching. Honestly, I was in Fairbanks Alaska when I did mine so I ended up just buying a brand new one from the dealership. But I would start scouring the junkyards first. The M205 was put in so many vehicles, it shouldn't be hard to find. Just make sure you get the right gears unless you plan to upgrade those like I did.

[@logangodwin4739]

I’m brand new to the Nissan community. Just bought a 2010 xterra off road. First thing I did was put Bilstein 6112 on the front with eibach coils and 5100 in the rear. Do I need a different front shock if I want to do a titan swap?

[@Flying_Dollar_Motorsports]

Depends on him much lift. You'd need to measure your rear shocks length or look at the specs if you have that info. You'd likely need to replace the front because of lift and the removal of the front sway bar. You need stiffer springs up front to make up for the lack of away bar. If you really wanted to keep your front springs, you'd have to look into a spacer lift for the front and you may need a Titan UCA too. You'd have to research that because I'm not sure if the upper coil buckets on the X and Titan are the same

[@glennsakamoto8573]

Thanks for the video. If I have a 6spd 2007 xterra and titan swap it, can I retain the 6spd?

[@Flying_Dollar_Motorsports]

If you don't swap the engine sure

[@jsa1742]

Is it me, or is the voice audio only coming out of the right side?

[@Flying_Dollar_Motorsports]

Seems ok on my stuff but I'm not watching it with stand alone speakers. Just using the laptop. I wouldn't know how to fix it at this point?

[@nuttynuts4601]

@@Flying_Dollar_Motorsports If you have any speakers laying around you can test audio that way to check, idk what editing software you use but I assume there should be an audio setting to configure for surround sound

[@Nd4SpdSe]

Ya it is. I have right speaker issues and so I don't get any sound except in the intro and a few off sounds.

[@kanenaysmith9287]

can you point me in the right direction to do the engine swap from Titan to frontier please

[@Flying_Dollar_Motorsports]

Here's a how to. www.thenewx.org/threads/how-to-swap-2ndgen-vk56-pbr.107289/ These guys are experts too www.offroadgorilla.com/shop/vk56-engine-swap-custom-harness-for-05-12-xterra-frontier-pathfinder

[@Flying_Dollar_Motorsports]

Another good guide www.alldogsoffroad.com/alldogs-offroad-titan-swap-guide

[@vagelisperrakis826]

Where has 3rib the m205 at the top or at the bottom?

[@Flying_Dollar_Motorsports]

Top

[@mattwernecke2342]

Can you estimate the cost involved in switching the engines?

[@Flying_Dollar_Motorsports]

Im guessing your talking a VK56 swap which is often mistakenly called a Titan swap. I have not done that but it's gonna depend alot on what type of engine you get (salvage, rebuilt, new) and how much work you can do yourself. If you Google Off Road Gorilla, they have done it and can give you a lot of info as well as build you a wiring harness that you'll need.

[@vagelisperrakis826]

hello . very nice video. from wich year and after m205 it's sronger?

[@Flying_Dollar_Motorsports]

I believe it's 2008 and newer.

[@vagelisperrakis826]

@@Flying_Dollar_Motorsports I have one navara D40 v6 diesel on 35's and i want to do titan swap. Thanks for the answers. You make very beautiful videos, I follow you.

[@Flying_Dollar_Motorsports]

@@vagelisperrakis826 Yeah I've been watching your stuff this morning. I WISH we had diesel Frontiers in the US. I'd have one for sure!

[@vagelisperrakis826]

@@Flying_Dollar_Motorsports it's amazing. It has very much torque..

[@wrwarrior]

Video is missing sound apparently.

[@zillaRN]

Sound was good on my playback

[@zillaRN]

Sound was good on my playback

[@wrwarrior]

Welp it would appear that I’m the jerk here. Sorry about that and carry on. Guess I’m watch a T-swap video, oh no.

[@jorgemireles9308]

Would it work on my r51?? The Titan swap??

[@Flying_Dollar_Motorsports]

If your talking the Nissan Pathfinder of the same generation as my truck, yes you can do ot

[@marcusiya1915]

Hi, just asking if can use the UCA of titan or armada to 2012 pathfinder?

[@Flying_Dollar_Motorsports]

You can but you will have clearance issues at the top of the coilover.

[@marcusiya1915]

@@Flying_Dollar_Motorsports actually there is 2" spacer on the coil spring coz my pathy modified with 2" lift kit but my issue right now the stock UCA when drive over into those bump it hits to coil spring frame or whatever called is.

[@Flying_Dollar_Motorsports]

Well you can only use the Titan or Armada UCA if you do the Titan swap. You can't use the UCA without the corresponding LCA. And your 2" spacer will not for coilovers used in a Titan swap. It will only work with factory coils

[@marcusiya1915]

@@Flying_Dollar_Motorsports ok go it, thank you for your information.

[@eclipseix495]

What year engine did u place in your vehicle??

[@Flying_Dollar_Motorsports]

It's the original engine

[@yortchylanissancita3583]

Check out my Titan swapped 2022 Frontier ….

[@Flying_Dollar_Motorsports]

Very Nice. Love the color. What part of Colorado?

[@yortchylanissancita3583]

@@Flying_Dollar_Motorsports commerce city Colorado where you from

[@Flying_Dollar_Motorsports]

@@yortchylanissancita3583 Currently in the Springs

[@yortchylanissancita3583]

@@Flying_Dollar_Motorsports cool any good trail worth mentioning???

[@Flying_Dollar_Motorsports]

@@yortchylanissancita3583 There's a ton of trails. Lots on the west side of Denver. Look up Trailsoffroad.com. Great trail guides

[@Flying_Dollar_Motorsports]

I don't know boss. I just checked it on another computer and even had someone else check on their account and it worked. Anyone else watching have this issue?

[@wrwarrior]

My bad for sure. Looks like a kid grabbed an ear bud and I’m the turd here.

[@Flying_Dollar_Motorsports]

@@wrwarrior lol no problem. You had me sweatin' though. Thanks for watching.

[@carlossalazar2164]

Qx80 axles work direct swap and gives the extended axle

[@Flying_Dollar_Motorsports]

@@carlossalazar2164 yeah I forgot about that.

[@Flying_Dollar_Motorsports]

I put a correction in the description of the video. Thanks for the check.