Gen 5 Bushpusher Spring Bushings and Upper Idler Bracket Install

How to install the Bushpusher Design spring bushings and upper idler bracket on a Gen 5 Ski-doo summit.
Get em here - xtremeairvents.com/collection...

[@Ride4life311]

You should really just get rid of those torsion springs.. one of the first things I do to my sleds! Makes the handling of the snowmobile so much better. The Tom’s torsion spring delete kit. Also, Zbroz has a coil over RTS that is steller!

[@robb2498]

Well done Tommy Walters.

[@grutzmac]

Pls do a long term follow up. Seen a bunch of snapped torsion springs due to binding after installing these. Who knows.

[@xtremeairvents]

I’ve had these on my gen 4’s for a couple years. I’ve never heard of a spring breaking. I could see if using a brand that doesn’t fit correctly would cause binding but that’s not an issue with the Bushpusher’s they fit and don’t bind

[@stevehaver7545]

I cannot believe Ski-doo has a plastic part holding the rear of the sled to the track.

[@xtremeairvents]

You’re not wrong 😂

[@grutzmac]

Is injection molded plastic strong? How Strong Are Plastic Injection Molded Parts? - Nova ... The tensile strength of plastic injection molding is typically between 3,500 and 10,000 psi. This is significantly higher than metals' tensile strength, typically between 1,000 and 4,000 psi.Dec 12, 2023