Torque rod bushing Carnage

[@georgeburns7344]

Good ol' Acetylene Wrench!!

[@smashyrashy]

Youre so good at what you do i love the videos

[@zrathis]

as the ref signals with arms raised the crowd cheers the field goal its GOOD

[@familytraditiontransportat7951]

I've had that same struggle ... thankfully mine was on a semi so I could easily get to it from the top. I feel your pain!!

[@simcoespring]

the top down ones are easier for sure! This one was extra bad. I didn't want to cut it because of all the cables and hoses around it. oh well

[@deankruse8751]

I had a tie rod end with a tapered shaft like that in a 50 ton rock truck. I put a 20 ton bottle jack under it and stalled it out then still had to hammer around the shaft to get it to pop

[@kendallreed1711]

I take the washer off the back get the rod off and have a short piece of pipe and then put on the stub and put the washer back on and impact it,then try and beat it off, if not cut the threads off and pierce the center and when the taper shrinks it usually pops or will after you impact it some more. It is one of my least favorite jobs

[@michaelpatterson7088]

Nice video

[@simcoespring]

Thanks

[@johnmorrow1628]

The worst is garbage trucks. Heating, air hammering, Using a porta power, cutting. You do what you got to do to get them out. Worst one I had took me 6 hours to remove

[@simcoespring]

yes and yes, I worked on this one for an hour before I even turned on the camera. Anything with a body built over top of the suspension like this is a nightmare to work on.

[@Tombomb1816]

Tiger tool makes a tool for these, I used it yesterday and works great. The part number is 15200

[@realBlazeX]

Could I come by the shop and say hi?

[@jeffreykreft5442]

When in doubt burn it out!