How to Remove Lower Footwell Sill A Pillar Trim - Audi A4 S4 RS4 - B6 B7 - 2001 2008 - TOTAL TECHNIK

This video will show you how to remove the A Pillar Trim/footwell side trim from your Audi A4, S4 or RS4 (B6 and B7) 2001-2008. Saloon (sedan) and Avant (estate) models.
Looking for tools?
www.totaltechnik.com/selectstore
Video by TOTAL TECHNIK.

[@TotalTechnik]

Looking for tools? www.totaltechnik.com/selectstore

[@alrestauro]

A wealth of information here! Thanks for sharing!

[@zdavidzz]

Please do one video on the front footwell lights!

[@In2investing]

Hi Total Technik love the DIY videos. Quick question about the front door harnesses. Is there any access to the connector on the body side (not the door side that plugs in, talking about female connector) as the connector has come loose from its original position, and needs to be locked back in place. I need to get at the connector from the inside of the vehicle (Drivers side) and have had difficult time locating it. Wondering if it's under this from although it seems higher up in door jam area. Any insight would be greatly appreciated. Door will also probably have to come off as access is extremely tight. Thanks so much!!!

[@Trains0505]

Hey how do you do this on the drivers side with the hood latch

[@Michelle-uf4jh]

Thank you for posting this tutorial. By closely following your instruction (wiggle, not pull), I successfully removed my footwell pillar trim to access my TCM and electrical harness. Will you be posting how to remove/replace windshield cowl?

[@TotalTechnik]

Great stuff, that's what we like to hear! Yes, we probably will do a video on the windscreen cowl. They can bit a bit of a pain on the B6/B7 TBH. But a little patience goes a long way with them :-) Please be sure to support us: subscribe to our KZbin channel and help spread the word!

[@kieranreynolds8624]

You got a video with removing the Telephone Bluetooth module - which, under right hand (UK Drivers) seat ?

[@DaytonCarCare]

The A4 is probably one of the easiest cars to remove the interior. I am swapping almost a whole interior from another car. Seats, glove box, knee bolster, door panels/speakers, pillar/sill panels, center console, rear deck and steering wheel. You can knock this out in an afternoon no problem. Keep in mind if you're upgrading from manual seat with power lumbar to full power seat you'll have to change the fuse to a higher amperage (10 to 30). The passenger seat fuse under the kick panel and the driver's is under the knee bolster.

[@TotalTechnik]

Hey, great post. Yes, the B6 and B7 A4 platform is really nice to work on compared to others. Audi are generally pretty good compared to some other makes, but even some Audi are not quite so nice to work on. The A4 platform is very well designed, and pretty much everything fits together in a logical way. Yes, great seat upgrade opportunity. If you have manual A4 seats, then S4 Recaro's make a great upgrade as they are sensible money and fully electric. As mentioned here, you'll need to upgrade the fuse 10amp>30amp but once done you have full electric seats! Just make sure your old manual seats have an electric lumbar support (90%+ do!) Be sure to support us: Please subscribe to our KZbin channel and spread the word!

[@DaytonCarCare]

Yeah the only thing that was kind of fiddly was the B pillar cover over the seat belt. And the rear seat upper side panel needs a tubular spanner wrench to get the pole off that latches the pivoting seat.

[@TotalTechnik]

Yes, the B pillar is the worst pillar by far. How did you find out about the tube spanner trick ;-)

[@DaytonCarCare]

Only thing that would logically work since a regular deep socket is too thick walled

[@happysawfish]

@@DaytonCarCare : I'm struggling right now with a wet carpet emergency, and trying to remove the plastic trim at the rear of the driver's side door on an Audi S4 Convertible 2005 model and the corresponding plastic that will allow access to the pull up the carpet in the rear passenger footwell. I can't seem to get this plastic off. And that carpet is really stuck down tight. It's sopping wet under there. I have the driver's seat out, thanks to you Total Tecnik - and your wisdom in passing on the M10 spline bit which I was able to obtain, and the front carpet partially pulled up and the CCM exposed and open but have taken a break to try to figure out how to fiddle the clamps out. I think I can figure out how to undo the clamps with some more close inspection, but this rear carpet is killing me! Any tips would be appreciated and I can patreon.

[@A-DUBCLUB]

hey boss. any tips on removing comfort control module or Ccm

[@TotalTechnik]

Yes, it is under the left side front passenger carpet. You can remove the trim in this video and then carefully fold the carpet back. You will find the comfort control ECU within the black box beneath the carpet. Best of luck! Please be sure to support us: subscribe to our KZbin channel and help spread the word!

[@samron2521]

CHACE NGUYEN it’s below the carpet. Where he is working on.

[@markjones7346]

Hi there have you got a video of how to remove the carpet on a a4 b6 convertible?

[@TotalTechnik]

Not yet, unfortunately. Maybe in the future! --- To help support us (for both you and others reading this) there are a few things you can do: 1) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to www.paypal.me/totaltechnik 2) Please ensure you subscribe to our KZbin channel. 3) Please give our video's the Thumbs Up on KZbin. 4) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. Thank you for your support!

[@seanbarr582]

Any videos on removing the carpert from a B7?

[@TotalTechnik]

Not currently, but with enough support we want to continue bringing more and more content to our viewers here on KZbin! :-) So maybe for the future! --- To help support us (for both you and others reading this) there are a few things you can do: 1) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to www.paypal.me/totaltechnik 2) Please ensure you subscribe to our KZbin channel. 3) Please give our video's the Thumbs Up on KZbin. 4) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. Thank you for your support!

[@Dr33nic]

any vids on a audi A3 2010 SE sportback?

[@TotalTechnik]

Hey there! Not right now, we are looking at the A3 as a possible future model to cover. Right now we are on B6/B7 A4/S4/RS4 and we expect to cover the C5 A6/S6/RS6 shortly. But definitely interested in the A3!!! Be sure to support us: Please subscribe to our KZbin channel and spread the word!

[@Dr33nic]

Alright then no prob, thanks

[@bogdandogaru96]

Hello, I lost a clips in the hole, I tried to pull it out and fell inside the hole, what could I do to clip out there as scales noises. Thank you in advance!

[@TotalTechnik]

Hey there. I can't remember without looking, but can you access that 'tube' from either end? i.e. from the front corner of the footwell, or from the bottom of the B pillar? If so, you could get a magnetic tool in there (may need to be a flexible one) and try and get it that way. But can't remember if the end's of that 'tube' are open or closed. But that would be my first thought. Second thought, if that tube is sealed on both ends that it's not coming out that way! It depends on how desperate you are to get it out. You could try to locate wherethe clip is, and drill a hole in the top of the tube (which will be covered by the plastic trim so you will never see it) and retrieve it that way. An ugly solution, but gets the job done. Best of luck --- To help support us (for both you and others reading this) there are a few things you can do: 1) Please ensure you subscribe to our KZbin channel. 2) Please give our video's the Thumbs Up on KZbin. 3) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. 4) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to your PayPal account and select the Send Money option and send any donations to: [e-mail] Thank you for your support!

[@marsruben]

Could you please show us how to remove B pillar_ I removed it but I cant get it back in again, I just tossed it out. I cant find this anywhere on the web... (I just installed a new 4 channel stereo in my car, but the only thing I couldnt fix was the B pillar... Thanks! :)

[@TotalTechnik]

Hey there! Yes, this is something that we will be covering in the future for sure. However its not filmed as of yet so will be a little while in coming. --- To help support us (for both you and others reading this) there are a few things you can do: 1) Please ensure you subscribe to our KZbin channel. 2) Please give our video's the Thumbs Up on KZbin. 3) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. 4) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to your PayPal account and select the Send Money option and send any donations to: [e-mail] Thank you for your support!

[@amranali2084]

Hi, how can i remove the Lower B pillar..?

[@filipgustafsson2439]

Is it Almost the same on a 2012 A4?

[@TotalTechnik]

We're just about to start our B8 coverage, so hopefully we'll have some useful content for you very soon! --- To help support us (for both you and others reading this) there are a few things you can do: 1) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to www.paypal.me/totaltechnik 2) Please ensure you subscribe to our KZbin channel. 3) Please give our video's the Thumbs Up on KZbin. 4) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. Thank you for your support!

[@RunningCarrot]

Please help! One of my clips just got inside the upper hole of upper plastic section. Does anybody have any idea if it is possible to take that out somehow? Does this metal part has hole in it somewhere?

[@TotalTechnik]

Do you mean where this section links on to the lower A pillar plastic trim?? --- To help support us (for both you and others reading this) there are a few things you can do: 1) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to www.paypal.me/totaltechnik 2) Please ensure you subscribe to our KZbin channel. 3) Please give our video's the Thumbs Up on KZbin. 4) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. Thank you for your support!

[@RunningCarrot]

@@TotalTechnik I mean the clip shown at 2:44

[@TotalTechnik]

@@RunningCarrot So the clip has gone inside the metal hole?

[@RunningCarrot]

@@TotalTechnik yes, exactly

[@kiancool6707]

How do u remove the panel u Call b?

[@TotalTechnik]

Hey there! The lower plastic B panel trim is a proper pain, not in itself, but you have to remove the upper trim first. It's quite involved to remove just that trim! This trailer may give you some assistance: kzbin.info/www/bejne/m2Kuoq2oqcismpI --- To help support us (for both you and others reading this) there are a few things you can do: 1) Donations both needed and welcome! We cannot operate Total Technik without the support of people like you! You can donate by PayPal - just go to www.paypal.me/totaltechnik 2) Please ensure you subscribe to our KZbin channel. 3) Please give our video's the Thumbs Up on KZbin. 4) Please help spread the word, the more people who know about us the better! Add links to our video's in forums, let people know about us. Thank you for your support!

[@tomektomek5571]

ok

[@tomektomek5571]

how to remove the shell of the post b

[@TotalTechnik]

Hey there Yes, we have already filmed this actually. It will be uploaded over the next few weeks. Please support us and subscribe, then you will receive an automated message whenever we upload a new video. The lower B pillar trim actually lifts straight up - but it is a bit fiddly the first couple of times you do it. You need to remove in this video as it passes through one side of the B pillar trim. On the other side (rear door frame) of the B pillar the B pillar thim passes through the other lower trim, so it moves straight up and out. Good luck!

[@hoofin6764]

@@TotalTechnik hey, have u uploaded the video?