Toyota Avalon Sway Bar End Links

[@dougmacqueen1679]

Those with limited experience should never and I mean never talk about how easy a job is to do. I have almost 50 years experience in my trade and it has taken me a long time to learn to keep that advise to myself. And I am a master lever mechanic.

[@TheReeho]

why not, looks easy to me lol

[@richcastle]

I have an 06 , would it be the same you think? only the front struts were done. Would you recommend doing the tie rods and front links as well? Thanks

[@williamkincaid3222]

Should be similar. I think they made slight changes but close enough. Yes, change all while you’re there. Not too much money. I also just changed the Lower control arms but I didn’t film that - check the rubber boots to see if they are cracked or worn. That’s a bigger job though.

[@richcastle]

@@williamkincaid3222 ok Thanks!!

[@ferndog1461]

Got Moog Sway Bar Link ' Problem Solvers ' for noisy front suspension on my 03 Camry. I'm sorry I bought them. They come with zerk fittings but the installer needs to grease before first use. I went to my oil n lube shop, asked the veteran tech there if he could lube these, and he responded , " Can't help you. The grease guns don't work and aren't repaired/replaced because modern consumer automobiles don't take lub. ". Went to another oil n Lube, with $5 in my hand but same response.

[@lucidbarrier]

Buy a grease gun at any auto parts store, I bought one for $25 for the grease gun and $8 for the grease cannister. You unscrew the top of the grease gun, pull the lever at the end of the grease gun tube all the way back, pop the plastic cap off the grease cannister and then insert the cannister into the grease gun tube. Then pull on the bottle top on the end of the cannister and it's ready to go. Screw the grease gun cannister back onto the grease gun top, screw on your hose and pump the handle until grease comes out the end of the hose (you may have to push the lever up against the cannister to push out any extra air). Then attach the hose to the Zerk fitting and fill it up until grease spills out of the edges of the rubber and you are done. Easy peasy.