toyota clutch switch replacement

when clutch switch is not good can caused just like the start or relay are bad. in this case it happens time to time couldn't start and you have to pump the clutch pedal many times to start. hope this video help you and please help me subscribe thanks.

[@meyerjac]

I had been using my "clutch start cancel" button for about three years and after watching this video I looked and saw the connector had just come loose. I popped it back in and it's fixed. Thank you!

[@alltsab]

You welcome

[@dhick905]

😂a year and half of this and I watched this. Fixed in 3 seconds. It worked. Loose nut. Ty

[@karonmccormick3982]

Thanks, I have a had an occasional problem with this and have been wracking my brain wondering why it runs fine but every once in a while it won't start especially if you pop the clutch and it stalls out, the engine light comes on and won't start up again. It fires right up when I jump it and runs fine again. I will have my mechanic check this as well as all starting components, battery, alternator etc is just fine. I have a 1991 Toyota 5 speed4 wheel drive pickup that I love.

[@noe616]

Easy fix. Thank you for this video.

[@Sagemeister007]

Thank you. The white plastic stem, in my opinion, is too short. I think adding an extension by 1/2" would help.

[@71twodogs]

Great video ! Thanks for the help !

[@alltsab]

You welcome

[@genaroaviles7983]

I HAVE THE SAME PROBLEM, I WILL CHANGE MY TOMORROW, THANKS

[@fernandlandreville9038]

Merci

[@gilgitister]

Is that a cruise control stick on the left side of your steering wheel? If so, I need to know if the clutch switch you replaced is also linked to cruise control to disengage your cruise upon pressing the clutch? I have a manual Corolla 2012 and I'll be installing cruise control very soon. I see this switch on my Corolla clutch but I can start my car with or without pressing clutch anyway, I was thinking if it's the same switch used for cruise control or I need to get a cruise control specific switch, thanks.

[@Bhaisthenruas]

Thanks for the tip

[@alltsab]

You welcome

[@jamesweller616]

I have the same problems on my 2005 tacoma, V6, 4.0, 6 speed. I'll switch out that clutch switch and let e everyone how it goes. FYI the clutch cancel switch helps once in a while.

[@jamesweller616]

Changed the part and the problem is gone. Thanks.

[@alltsab]

Great job bud help me subscribe ok 👌

[@theronbain532]

Thanks very much!

[@alltsab]

You welcome

[@coolguy0421]

About to change mine. Has been happening lately. Had to push start my Matrix a few times.

[@alltsab]

Check test starter first incase starter is weak

[@shield2305]

How to know if the sensor is bad? What test to do?

[@tylerstiles8775]

I know im late but check for continuity between the two terminals while engaging the switch. You should have continuity when engaged. You can also clean these as they get gummed up after years of use.

[@joesezzz4324]

Get that video off to court TV maybe it can help