what an absolute awesome video. Thanks @simmo's Worshop
@ktm916684 ай бұрын
Great video, helped me out.
@michaelandrews47833 ай бұрын
Legend!
@CharlieBosie3 ай бұрын
Thank you You are the boss
@kungpaw16052 ай бұрын
With ABS how
@2hotty_ Жыл бұрын
I’d use a grinder to remove the collar personally…
@simmoshomeworkshop Жыл бұрын
😅 you're a genuine boily at heart Scotch
@bolivararauz2058 ай бұрын
How much is the capacity of the hydraulic press you use?
@simmoshomeworkshop8 ай бұрын
6 tonne, it is fairly at its limit pushing these, but it has worked for me. If I had my time again, I'd get the 12 tonne version.
@bolivararauz2058 ай бұрын
@@simmoshomeworkshop Very kind of you to take the time to respond, that will help me choose my future hydraulic press. Thank you
@plata_o_plomo7 ай бұрын
What post size you using?
@simmoshomeworkshop7 ай бұрын
The one to remove is a 50x50mm square tube around 750mm long and the base is around 100mm square (125mm would be a better size) The square tube I used to fit the collar is 40x40mm with a washer welded on the bottom to contact to collar squarely.
@nickn78959 ай бұрын
Instead of using a press could I use a hammer
@simmoshomeworkshop9 ай бұрын
Yeah I guess so, be sure to not hit the end of the spline directly, any "mushrooming" on the spline end and you can't get the axle back in the differential side gear, use a piece of wood or brass between the hammer and axle shaft if you must strike it. You will need a bit of force my press is good for about 6t and they can be tight. Carefully cutting the collar works too if absolutely necessary.