Toyota Tacoma Bull Bar Installation

[@allanfischer9417]

Good DIY instructional video with the kind of tips & tricks you usually don’t figure out until you are knee deep into the project. Good views on the video and good editing - Thank y’all!

[@BeyondtheBoom]

Thanks for watching and please check out my channel for more

[@ExploreAnywhere]

Ordered mine, but I hate how skinny the brackets look. Idk if a welder can make something custom. It goes from a 3” bar to skinny mounts and I don’t like it, looks weak

[@BeyondtheBoom]

Agreed

[@Popwarner-x1w]

I just ordered one and I thought the same thing. It's more just for looks I guess.

[@ExploreAnywhere]

@@Popwarner-x1w just realized I had responded to the wrong thread. But I’ve had mine for 2 months before the brackets broke. I use it daily in the desert and bumps made the wobble snap the welds. I had it reinforced.

[@Popwarner-x1w]

​@@ExploreAnywhereCool thanks. I'm finally getting around to installing my Bull Bar

[@ExploreAnywhere]

@@Popwarner-x1w enjoy!! Been a while time to make the truck better

[@anabelleesilva8111]

Thank you! Finally really good instructions can’t wait to install it on my Taco!!

[@BeyondtheBoom]

Thanks for watching and be careful trimming the splash guard if you use it.

[@drewrodriguez3877]

Hi! I got everything off except the hex nuts. How do I get those off my 14mm isn’t getting the nut 🥲

[@BeyondtheBoom]

You should be able to get them.

[@danieldasilva7068]

Mine are stuck on really tight as well i cant break them loose

[@sambee5748]

great video thank you. Can i still mount the license plate with no problem?

[@BeyondtheBoom]

Yes,

[@wb4514]

Good information. At 6:40 are you able to break the nuts loose with a 3/8 ratchet or do you need the leverage of a 1/2" ? Thanks.

[@BeyondtheBoom]

Get a 1/2 and make it easier on yourself

[@vanlan8888]

I would like to see how you trim the splash guard if possible. Thank you.

[@BeyondtheBoom]

Tin snips.

[@Shaunny101]

For the Bull bar bracket, how do you tell the left side bracket from the right side?

[@BeyondtheBoom]

They're marked

[@barbwire7449]

Does installing a bull bar interfere with any sensors on 2023 Tacoma?

[@BeyondtheBoom]

That will depend on which one you go with. This one does not interfere with mine.

[@barbwire7449]

@@BeyondtheBoom How about the "Rough Country". It is heavier.

[@matthewcaughey8898]

@@BeyondtheBoom I think anything that leaves the area around the sensor clear dose not bother it. Might have to use a bull bar to mount my amber Hella 550 fog light kit

[@aknadiri2520]

Is this any good? sturdy?

[@BeyondtheBoom]

It works fine.

[@PolkAudio-dv3bq]

Did it effect the sensor ?

[@BeyondtheBoom]

Not at all

[@GeorgeSawtooth]

Why reinstall the splash guard? My Off-Road Edition doesn't even have one.

[@BeyondtheBoom]

I just liked how it looked