Traxxas TRX4MT Brushless Upgrade. Full install of the Traxxas TRX4M Power System. Includes binding

[@360woodierc]

Thank you. 🙏

[@Goduvwar]

You are very welcome also your channel is very cool. Nice job 👏

[@360woodierc]

Thank you very much.👍🏼👊

[@ivanlara5815]

How much does this setup cost?

[@Goduvwar]

the Brushless system cost $119 directly from Traxxas.com. I will give you some insight. we a Currently filming the review of the brushless system for the side by side comparison and ended up blowing out the differentials. So just to give you some advice I would highly suggest buying the steel differentials as well.

[@johntegtmeier1173]

1st test should have been stock vs. stock right ???

[@Goduvwar]

They are the same truck with different bodies, so they would perform the same stock. Unless I am misunderstanding your question.

[@johntegtmeier1173]

@@Goduvwar I believe even if they came off the assembly line one after the other they will have differences, maybe not measurable differences but still, maybe quality control is better than that but than again the only way to know is to test, Not trying to be a pessimist just trying to cover all angles:)

[@jayhendrix7343]

Surprised nobodies released a licensed decal sheet for a Clodbuster or Big Foot with these 2 rigs alone

[@Goduvwar]

I agree

[@360woodierc]

Thanks for posting. Let me know if it gets really hot. My traxxas brushless motor gets very hot.

[@Goduvwar]

You are welcome. Brushless motors are usually safe up to about 145 to 150 degrees. So it will be hot to the touch but may still be ok for the motor. You can check it it a cheap ir temperature gun. They are like $15 but are an easy way to check your system. every vehicle is a little different, so pick one of those up to monitor your vehicle. Also check to make sure something is not causing any binding in the drive train. That can cause heating as well.

[@elbutchos]

After installing the brushless systems set it to Crawl Mode and do some super slow crawling. Please let us know if the motors get extremely hot. Thank you in advance.

[@Goduvwar]

No problem,I will do some testing today or tomorrow.

[@Goduvwar]

kzbin.info/www/bejne/hneqYpeajdOMgaMsi=gbUOi30KXxazkZnk

[@RCRitterFPV]

that transmission have no bearings? just bushings? how have you tried this with the high speed transmission?

[@Goduvwar]

I have installed bearings in both vehicles now. I did install the high-speed gears but removed them immediately. With the stock motor and the high speed gears, the truck did not have enough power to function properly. Low speed driving was not possible. Then, I tried installing the high-speed gears with the brushless system, and it created way too much heat on the brushless motor. It would have burned up. For the type of driving we do with these, the brushless system and the stock gearing work perfectly. And it can still crawl if you want it to.