I have the same issue going on. Changed ribbon cable 2 times, changed cut carrige sensor, change cut carrige board still says invalid id right pos. Any help with this would be greatly appreciated.
@rmwjohnson7 жыл бұрын
The problem is that he had the 'left' edge pinch roller in the center. Notice how it paused in the middle as it went over it but it never paused on the very far left side? Invalid left pinch roller was the message he got. He simply had the wrong pinch roller in the left position. Swap the pinch roller on the very left edge with the one to the right of it and his problem would have gone away. You can verify this is true by how the tool carriage paused over the very far right pinch roller.
@JamieHuntLCFC6 жыл бұрын
the end pinch rollers don't come out its only the centre 2 pinch rollers that come out , i have the same problem and just trying to find out it could be to do with the encoder strip
@ronaldmartins9839 Жыл бұрын
Change the flat cable of the clipping cart, but first clean the sensor behind the cart.
@abcprintingcompany38504 жыл бұрын
The problem is in the flat cable cut car,I had the same problem and so I solved it by changing the cable cut car,Good luck.
@timkaz2274 жыл бұрын
Had this issue a couple month ago. it was the ribbon cable. There was no visible signs of wear, the wires inside just wear over time.
@roodmnt7 жыл бұрын
Went through the same procedures, but the best we can get is 0mm media width reading....
@johngolojuch67644 жыл бұрын
When mine did this, I just installed a new ribbon cable, not the encoder.
@neilcotter69037 жыл бұрын
did you ever find a solution?
@DaudsWorld6 жыл бұрын
I wonder if he fixed it.
@xtremegraphics30117 жыл бұрын
el problema es el cable blanco flexible que va de las tablillas a la navaja de corte
@mazrotulosrotulacioncomerc82133 жыл бұрын
El cable al que te refieres es el transparente ???
@universodascopias49657 жыл бұрын
same problem... did find the solution ??
@pj-lw5sj6 жыл бұрын
final solution change : cable card
@uneedasign637 ай бұрын
Ribbon cable everytime
@Hossam_world5 жыл бұрын
I have same problem, What can I do?
@tamraloomis4592 Жыл бұрын
Can you tell me how to find the ip address in this machine
@reidoadesivo54277 жыл бұрын
The problem is in the flat cable cut car. I changed cable and finished the problem.
@mysterenigma93616 жыл бұрын
My Roland SP540V only came with 2 pinch rollers (Ones with wheels) So altogether it has 2 with wheels and 2 metal ones. Is this right? Thank you
@rainyjr686 жыл бұрын
hello do you know if there is a video on what the exact part is and/or how to change it? Thanks
@novacriativo5 жыл бұрын
Você poderia me dar mais informações sobre essa manutenção?
@crgrove7 жыл бұрын
I suspect he posted this "public" so that he could show a techie... this was not for us, methinks.