Troubleshooting AC Servo Motor Holding Brakes

[@hosseinranjbar2810]

Hi. Rob. Thanks so much for your super test and explanations!!!! God bless you and precision zone.

[@TheGuru0001]

Hi I am glad to hear this but I need a help we have a bridge stuck in upward position weight 2 ton so if I releases brakes with a switch. Control will it be possible to control the down movement just by on off function by a switch control power supply

[@hoanbui4346]

Thank for this video. Can you explain how to find the good ground if I do not have that device? Thank you very much!

[@tejeshwvardhan1165]

Can a AC servo generate holding torques same as stepper ?

[@AnilYadav-wp6gs]

f07841 faults in servo motor what would be the reason

[@mssaifi3400]

Hello Rob please let me know if servo motor (with break) don't have power supply so can we rotate motor shaft with hand? Our motor having little play both side

[@hosseinranjbar2810]

Hi. Yes you can, but very little in cw or ccw turn.

[@hinrigardehes3253]

Hello, can I know the type of the motor, I mean, synchronous or non-synchronous without opening it, and how is that? Thank you very much

[@abdallaaltayeb6627]

how are you sir i hope you are fine i have problem in may machine it is a blowing machine i don't know the problem but the servo hanging during work every one hour i need you suggestion about that

[@seimela]

or just download the datasheet of the motor to find the releasing voltage

[@TheFabricator03]

It would be nice if that was always the case.

[@tuhinasifmolla5711]

My embodary machine servo motor get wet due to amplun cyclone rain water. I don't know what to do next ? Does it will work if I start machine ?

[@moniruzzaman8568]

Zoro adjustable encoder steering method ?

[@blackhead2272]

Hi, I’m using servo motor for juki -LH3168(double needle) but now the motor shows E16 ( error16 ) and its starting is good but after that is not working so could you tell me how to fix The E16 please? Asap Thanks

[@komandos177]

show how to connect the motor Fanuc A06B-0186-B675#0014 2000RPM 3.8kW Motor to a wood lathe so that the spindle is like a rotary axis and which controller is suitable or replace with another cheaper one

[@dylankuhn2639]

I am thinking of making a project that with a giant servo motor that are used for a car engine. Great video, Regards.

[@dylankuhn2639]

Okay, thank you for letting me know that sir.

[@MohammadSadiq-kn1jf]

How to find the pin i have to supply 25 to 90 volt

[@Tony-t1t6x]

24 or 19 v

[@vinnatv4150]

Good job

[@warrenjones6290]

Too quick, could of done with you showing how you found the correct pins on the multi pin servo, as wouldn’t want to Megger the incorrect circuit

[@scottbrafford3989]

Nice

[@vishalkumargm2551]

Hi

[@mdsumonjan9570]

1pash ces pr 12 13 14