How to Replace Upper Control Arm Mounting Bracket 1994-2004 Chevrolet S10

Buy Now!
New Control Arm Mounting Bracket from 1AAuto.com 1aau.to/ia/1ASMX00179
This video shows you how to install an upper control arm mounting bracket on your 1994-2004 Chevrolet S10.
This process should be similar on the following vehicles:
1994 Chevrolet S10
1995 Chevrolet S10
1996 Chevrolet S10
1997 Chevrolet S10
1998 Chevrolet S10
1999 Chevrolet S10
2000 Chevrolet S10
2001 Chevrolet S10
2002 Chevrolet S10
2003 Chevrolet S10
2004 Chevrolet S10
Tools you will need:
• Pry Bar 1aau.to/obu/1AXAA00020
• 18mm Wrench
• 19mm Socket 1aau.to/ocz/1AXAA00043
• 22mm Socket 1aau.to/oR/1AXAA00266
• Pickle Fork
• Trim Tool Set 1aau.to/obQ/1AXXX00006
• Straight Cutters
• Air Chisel 1aau.to/of/1AXAA00270
• 15/16 Inch Socket
• Ratchet 1aau.to/ogQ/1AXAA00016
• Socket Extensions 1aau.to/oga/1AXAA00015
• Swivel
• Torque Wrench 1aau.to/odL/1AXAA00044
• sanding disc
• Sandpaper
• Floor Jack 1aau.to/obT/1AXAA00068
• Hammer 1aau.to/obd/1AXAA00091
• Jack Stands 1aau.to/obH/1AXAA00065
• Large C-Clamp
Subscribe: / @trq
Check out our playlist:
Chevy S-10 2nd Generation 1994-2004: • Chevy S-10 2nd Generat...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@ramonirizarry2596]

THANK YOU , VERY MUCH.

[@flir67man84]

Just installed my new upper ball joint after tightening with impact i have more on my shaft than you . Can we use multiple washers to take up slack? Then install castle nut ? And cottorpin

[@Tinker3504]

If you don’t install the lock washer on the bolt, are you basically just saying F the alignment shop? 😂