How to Replace Front Lower Control Arms with Ball Joint 2012-2017 Toyota Camry

Buy Now!
New Control Arm with Ball Joint from 1AAuto.com trq.video/id-1...
This video shows you how to install new front lower control arms with ball joint from TRQ on your 2012-2017 Toyota Camry. Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear, or integrated ball joints that require replacing the entire arm when they wear.
This repair was done on a 2014 Toyota Camry SE 2.5L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2012 Toyota Camry
2013 Toyota Camry
2014 Toyota Camry
2015 Toyota Camry
2016 Toyota Camry
2017 Toyota Camry
Tools you will need:
• 19mm Wrench trq.video/oaaY...
• 17mm Socket trq.video/ob3c...
• 19mm Socket
• 21mm Socket
• 22mm Socket trq.video/orH-...
• 1/2 Inch Impact Gun trq.video/oxW-...
• 3/8 Inch Impact Gun
• 1/2 Inch Breaker Bar trq.video/orw-...
• Socket Extensions trq.video/ob3c...
• Swivel
• Torque Wrench trq.video/oa7Q...
• Anti-Seize Grease
• Gloves trq.video/oaWz...
• Rust Penetrant
• Safety Glasses
• Floor Jack trq.video/oauu...
• Hammer
• Jack Stands trq.video/oagx...
• Rubber Mallet
Subscribe: / @trq
Check out our playlist:
Toyota Camry 2012-2017 7th Generation: • Toyota Camry 2012-2017...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@ReeseBain]

Very informative video. I had to undo the front motor mount in order to raise the engine to remove the transmission mount.

[@nuguseteferi188]

Nice video; easy to understand

[@marcusrobinson3918]

I was priced 10 hours labor to have this procedure (right lower) done on my 2015 Lexus ES350. By your demonstration this looks less than 2 hours, am I seeing this right. A place quoted me the labor for an upper control arm front control arm right, but this vehicle does not have upper control arms????

[@MaverickML-om4fm]

😢😢😢😢 this Rotor ?

[@MaverickML-om4fm]

😢😢😢😢 this Rotors

[@soulshinobi]

Why would you go through the trouble of removing the knuckle when in your older video replacing just a ball joint on the same vehicle it wasn't required? kzbin.info/www/bejne/Z5Ccq62JmLlkmpY EDIT: Oh it's because you had already planned on replacing the knuckle, it's definitely not required.