Tub Clog That Turns Into More/ No Power In Bedroom

I unclog a drain and run into more issues. I fix a electrical issue with the bedroom and find out its a breaker.

[@jeffanderson6000]

Nice to finally see a clean bathroom in your videos 🤣

[@thehandymanexperience226]

@@jeffanderson6000 u and I both enjoy this 😂

[@Eddy63]

Good morning , good morning ... Thx for the ride along ... Good vid

[@thehandymanexperience226]

@@Eddy63 thanks!

[@davidhampton7531]

Great video Brian!

[@thehandymanexperience226]

@@davidhampton7531 thanks! If u don't have the knife I would definitely recommend it. Its definitely ugly but the flat blade part is amazing

[@davidhampton7531]

@@thehandymanexperience226 I'm going to have to get it. Where did you say you bought it?

[@thehandymanexperience226]

@davidhampton7531 off Amazon I put the name in the vid.

[@davidhampton7531]

@@thehandymanexperience226 Thank you.

[@Techhead777]

Brian, I sure hope you figure out how to upload/render in 4K again. Right now your uploading in 1080p at 60fps. This has been since December 2nd, 2024 when you mentioned getting a new computer. The computer probably ripped through the video so fast in rendering because its 1080p, not 4K, and it does make a big difference! Especially for those of us that have 4K TV's. The video size doesn't matter because KZbin compresses and re-encodes the video after upload. Generally, KZbin recommends at least 20-25 Mbps for smooth 4K playback, otherwise they'll get buffering or forced to watch in a lower resolution. If it works uploading in 1080P and you don't want to mess with it, that's fine. Just figured I'd mention it. 4K is a game changer and many content producers are starting to upload in 4K which looks awesome and we can see a lot more detail, even on the close ups, like model numbers, product information etc.. Thanks. Btw, 4K at 30fps is fine, 60fps would be for fast motion you'd like to slow down in like slow motion and its smoother, but not a necessity.

[@thehandymanexperience226]

@@Techhead777 yea I don't know what happened, I got a new computer and and put it in 4k like normal and it was taking me like 10 hours to unload the video to utube

[@aaronsherwood4835]

Great work. I got that same utility knife, comes in handy but is kinda cumbersome

[@thehandymanexperience226]

@@aaronsherwood4835 Believe me, I know I Love my Milwaukee knife but I don't want to carry two knives around so, this one wins. By a long shot!

[@pit4955]

Are you doing repeats? Seems I’ve seen many of these seens😂 those lineman’s insulated gloves are a dead giveaway 😂. Another rambling vid 👏👏👏 great troubleshooting 👍👍

[@vince6829]

Nice job, as always!! Question: It looked like that MLO panel was being used as a sub-panel (you mentioned that the main panel was in the electrical room). Shouldn’t the grounds and neutrals be separated in that main lug only panel? Maybe I missed something. Thanks for sharing your knowledge.

[@thehandymanexperience226]

@@vince6829 there is just a main breaker in the electrical room no panel. But yea sub panels are supposed to have the neutrals and grounds separated. This is a older place before that rule was made

[@mainj54]

I cant believe you reached in between those breakers with bare hands in front of the exposed buss to remove a sticker.

[@thehandymanexperience226]

Shame on me

[@KamalasVACANTwomb]

The price jump between the rigid k400 and the 750 is ridiculous. Roughly $600 for the k400 and you can use up to 1/2 cable 75’ and the 750 uses up to 3/4 cable at 125’ for $2500.

[@thehandymanexperience226]

It's ridiculous!!! It's showing where our money the dollar is going!. Thanks for watching!

[@MattHmm-rq6dn]

Its nice when the setup takes longer than the actual procedure. All that ppe i just use my volt claw and fisher price knipex needle nose and I'm set. Don't underestimate how many layers of paint are around thoes boxes. I opened 2 last week from the 70s and they had the original paperwork inside the box touching a ground wire. Paper dosent bond wires to grounds who knew?

[@MrGaborseres]

👍

[@tomdale1313]

thxs for sharing...

[@matthewg7835]

Thanks for sharing. What gloves you using for the panel work? You have a link?

[@thehandymanexperience226]

I don't have the link, I got them from uline and I think there rated for 500volts

[@polishsharpshooter2876]

Sound is fine. The zip it was telling ya bro

[@thehandymanexperience226]

Lol 😆 bro stop ✋️ lol 😆 u got me sitting here rethinking this is definitely true on normal drains but in rentals anything goes 😂.your totally right I should have starting screaming but my senses are numb 🤣 u could only imagine what I don't record 🤣 comments like this I love cus u know but u never know lol thanks for watching bro

[@JRamirez9oh9]

Seen them K400’s out here in Cali for $750!

[@thehandymanexperience226]

Yea I heard Cali is crazy expensive!!!

[@chrisc9389]

those larger sectional cables are 1.25" I use them and drive it with a hammer drill with an adapter

[@Jeff-xy7fv]

22:29 - I would just replace all of those old breakers. Those look disgusting. Check the brand of the panel and determine which modern brand is listed for replacement use in that panel. It would be either Eaton BR or Siemens (one or the other).

[@CrashBr0]

No way to kill the power to that panel?

[@thehandymanexperience226]

U could shut the main breaker off but I didn't feel it was necessary in my occasion

[@MokenaBob]

Rubber gloves and leather. Must be scared of electricity. Sorry Brian it's just me

[@thehandymanexperience226]

@@MokenaBob lol 🤣 gotta keep the people viewing happy plus lol it's kinda fun getting made fun for using them.

[@GabesApartmentjourney]

What gloves are you wearing? Looks like a rubber pair and leather

[@thehandymanexperience226]

@@GabesApartmentjourney I can't remember they are way over rated for it lol I wouldn't say I'm just wearing rubber gloves

[@natashaball316]

Have you looked at the Milwaukee pack out structured backpack? it looks very similar to Veto Pro Pack! Cool video Brian! Happy to see you gloving up!

[@thehandymanexperience226]

Believe me I was thinking about it but it only goes a 1/2inch cable

[@andyvitz]

by the way this video has no audio

[@thehandymanexperience226]

I'm watching it right now I could hear it bro. Try refreshing and restarting it. But stuff like this definitely helps out. I'm not perfect

[@user-vj3wd3ge4l]

You have audio, no issue anywhere in the video.