Thinking of doing the same project, excited to see how it turns out!
@dillpickle746824 күн бұрын
Great video.
@Joebie32 ай бұрын
I felt that drill bit snap in my soul.
@Drive.Revive.Tinker2 ай бұрын
Preeeeach. Thought I was going to get so much done that day, and then bam-day ruined
@roadracer4life2 ай бұрын
Going with a MaxxECU Race in our Flyin' Moose endurance car. Looking forward to seeing your progress.
@Drive.Revive.Tinker2 ай бұрын
Nice! I’m excited to upgrade from Megasquirt. Should be fun to get that all set
@tylerdomond10872 ай бұрын
ahh just what I need after a really rough and shocking day... a volvo video. Keep up the good work.
@Drive.Revive.Tinker2 ай бұрын
Enjoy!
@stevemartin55812 ай бұрын
When welding a broken stud like. Place a copper washer over the hole and weld in spots the stud to build it up . Remove copper washer clean up the weld knob place nut over this knob and do a deep weld .
@Drive.Revive.Tinker2 ай бұрын
Good tip, thanks!
@reinierwelgemoed81712 ай бұрын
The VHT high heat header spray has proven to be massive bang for buck as well when it comes to coatings manifolds and turbine housings. I've done probably like 40 - 50 different manifolds with the VHT coating and holds up remarkably well.
@Drive.Revive.Tinker2 ай бұрын
Oh interesting. Any special prep you do? Aerosol can makes it even easier, but I haven’t had luck with the aerosol products I’ve tried
@TomSlaten2 ай бұрын
Man those sheared off bolts were a doozy.
@Drive.Revive.Tinker2 ай бұрын
Yeah… that’s the unseen pain of car projects 70% of the time 🥲
@brentmoger93512 ай бұрын
What engine mounts did you use to put the t5 in
@Drive.Revive.Tinker2 ай бұрын
They are one-off brackets with Volvo 240 passenger side engine mounts.