Two Ways To Change Working Position On Hydraulic Jack Horizontal and Vertical Working Position

[@gilsonfelix3415]

Fantastic, I always thought that the jack to work horizontally needed to be manufactured for. Thank you.

[@cvsundar-ti7oh]

An Amazing and wonderful Idea which will help Engineers in Special purpose. Thank you.

[@OliverlifestyleJa]

Awesome job my brother, well done 👍

[@triggerhappy8872]

Good idea dude 👍👍

[@ovalwingnut]

Hard Core "Jimmy Rigged"..... I LIKE IT!

[@TheGathumpus]

Will the other holes/inlets that are not piped suck air if the oil level drops to low, or in the case of upside down all the time?

[@saburoy3311]

Yr doubt is genuine In both positions air will go in and won't function properly

[@tonydewey3023]

Been looking for this, thanks

[@rickypangpang9343]

No need to do all this. only take out the side rubber Plug & insert a rubber or pu tube to it than connect to the bottom of a bottle that fill with hydrolic oil. The Jack will always full with oil than can Work on any position.😊

[@albertchiu655]

what is the purpose?

[@michaelnovak9766]

The copper pipe added , works at the lowest point when in operation. Plus one is never going to operate the jack with no oil. So the concern added won't be a issue. The only thing I would consider is using a slightly oversized inner hole diamater aluminum or copper washer on the oil plug bolt, that the o ring seal he added will locate internally in for a better seal on the vertical modification one 🙂

[@perezoso44]

Como va fincionar si dejaste abierto

[@med1273]

LAY ON SIDE TO FILL NO NEED TO DRILL OR WELD

[@paulphotios3920]

Or buy a masada.