Updating Emlid Reach Products Using the Reach Firmware Flash Tool (Newer Version Available)

[@TONY...GTB6]

These are some underated tutorials

[@elvismaria5483]

Hello, I have an emlid reach rs+ (bought 2nd hand). I am faceing an issue with it. I cannot turn it on. By pressing the power button for few seconds, I get all 3 leds solid light but when I release it, it goes into power off mode. I tried to use their software for firmware update but without any succes (all lights stay solid and after few seconds power off again). Can you help me with some directions to solve this issue? Thank you.

[@e38surveysolutions59]

Sounds like a battery issue, I would leave it plugged into the wall charging for a day then try to power it on to see if it can hold a charge at all.

[@elvismaria5483]

@@e38surveysolutions59 Thank you for your reply. I decided to open the cases for both the units I have and just switch the bateries to see the effect on both the units. Both units are now fully funtional. I also did the flash but just after I succeded to turn them on. Hope this comment will help other guys facing the same issue.