Upper and lower intake gaskets replacement (01-08 Ford Escape 3.0L) - Part 4

Part 4 - Putting it all back together
This is Part 4 of a 4-part series on changing the upper AND lower intake manifold gaskets on a 2004 Ford Escape. This video shows putting the intake manifolds back on the engine, plus components attached to them. Covers years 2001, 2002, 2003, 2004, 2005, 2006, 2007 and 2008. Also applies to Mercury Mariners and Mazda Tributes.
Parts:
Part 1 - Removing the upper intake plenum
• Upper and lower intake...
Part 2 - Removing the lower intake manifold
• Upper and lower intake...
Part 3 - Replacing the gaskets
• Upper and lower intake...

[@timvest8141]

Excellent series.

[@makachoise]

love the way you thoroughly explain and indicate the procedure step by step. because of that i was able to repair my 2001 mazda tribute and now it idle steady and runs great .thank you ,thank you.

[@GreaseMonkeyFever]

Good, makachoise...I'm glad the video helped you. Thanks for watching!

[@th3frogman]

What were the symptoms of which you decide it was necessary to replace your gaskets?

[@jimsz0100]

All four parts were very detailed-I can do it now. Thank you. I had the upper plenum off two years ago to replace the coils and plugs on the rear bank. I expect replacing the gaskets on both the upper and lower will fix the rough running when cold.

[@fordman7479]

Why does google say 21ft lbs for the lower on a 2008?

[@kevink6074]

Need an assist have 2 10mm black bolts with shoulders on them, can't seem to determine where I left them off.

[@RickyPisano]

Great presentation. Very easy to follow. Will this be the same on a 2005 Ford 500 Limited 3.0L Duratec DOHC V-6? Thanks a million!!

[@kcaviatrix]

The no audio thing led to a man screaming at me, out of frustration. A voice over would have immensely helped!

[@jtcowhand]

Great video and I appreciate the way you showed the procedures.

[@jonderrick25]

Where does the other end of the outlet hose connected to the evap canister purge valve go to

[@oldmanhads2043]

Bottom right side, at the back of the plenum, you'll find a plastic tube to put the hose over. He has another video for this same topic which shows you a better view.

[@enriqueatala2567]

Hello, in the lower multiple that rests on the metal block that you. Did you clean or don't put any type of grease on the joints?

[@Garyscott7]

Have not seen an instruction video & careful production quality done better. Thank you.

[@imaginaries8997]

egr valve didn’t come in my set glad i watched this before picking up my parts thank you

[@leesmith124]

Great content and presentation style!

[@galepatterson670]

how much does a shop charge to do all this

[@125bamf]

I was quoted $750... I replaced the EGR valve, the idle throttle sensor, the gaskets, spark plugs and coil packs for less than $150 and 4 hours of labor... talk about a rip off...

[@josefranciscoesquertalaman3827]

*Like !!!*

[@pauldee4976]

89 ft pnds on the lower and upper huh?

[@brettabernathy3167]

89 in/lb (INCH) I had to do a double take myself when I first saw it!