Using Annealeez

Brass Case Anneal

[@bucstart]

Great video, as always HL!!! Thanks for taking the time to put these high quality and informative videos together.

[@Annealeez]

+scrrady I will thank HornadyLoader for you.. he does do a great job..

[@bucstart]

Much appreciated, as you can see, I ordered one of your machines. Don't get me wrong, I know he is not getting paid to present you machines, his detail simply answered the questions I had. Thanks again!!

[@jat2409]

I am having issues with the case not turning, it rotates a few times then stops, but the wheel is turning. Any help.

[@Annealeez]

Please watch this video if you need to time or clean your bottom wheel kzbin.info/www/bejne/fmbPiYCEeqtlptk

[@Annealeez]

Check out this video by XTreme Reloading on Rumble.. rumble.com/v2c8cgw-extreme-reloading-special-edition-does-annealing-work.html

[@usmc-ff9464]

Ordered my Annealeez today. Saw the video from Long Range Shooters of Utah and I was sold. Looking forward to more consistent neck tension for my F/tr rifle. Also Jeff, for the price I don't mind waiting 3-4 weeks!

[@Annealeez]

+USMC-FF We are getting the wait times back down again.. should be two to three right now.. Thank you for your purchase!

[@boba1618]

Mine was shipped today....but time I got around to getting one.

[@MaxairEngineering]

Just ordered one. Can’t wait to get started. One question: will the standard setup do 7mm mag? Thanks!

[@Johnyrocket70]

if you think you over annealed a piece of brass you can re harden it running it thru a resizing die a few times.

[@kevindonkin716]

Will there ever be a digital speed display so we can get back to a previous setting more accurately?

[@IEraiderfan]

Looks like a very well made product good video.

[@Annealeez]

Lou Flores Thank you very much..

[@southernraisedandrespectfu2518]

What does the lower wheel use for a non-slip surface? Looks very well designed and fabricated.

[@Annealeez]

+Southern Raised and Respectful the coating is a high heat resistant silicon

[@TheSgtk9]

Nice vid, have you timed your burn time using Tamplac (750 Degree). Is 5 seconds enough? Thanks

[@Annealeez]

+TheSgtk9 yes, everything has been timed using Tempilaq.. 5.5 seconds is what i run it at. but it also depends on how high you run the torch/flame.. once you have run it a few times you'll have it down for what you want.

[@larryd1296]

@@Annealeez 750 degrees is not hot enough to anneal the brass. You need 1000 - 1050 degrees to properly anneal brass. Read up and investigate the issue!!

[@johnsousouris9457]

It looks like nicely made and functions as intended,,,,,the only issue is with the torch holder,it looks like an electrical copper cable ground clamp,,,,,not well functioning,,,too much fiddling around to get it at the proper angle and distance,,,,,,other than that I think is worth the money and works better than double the cost of some others,,,,,,

[@Annealeez]

+John Sousouris thank you.. there are other suggestions from customers on ways to hold the torch.. check out the Annealeez Facebook page.. facebook.com/annealeez

[@Annealeez]

[@jordanwalter4381]

What do they cost?

[@Annealeez]

Jordan Walter you can go to www.annealeez.com for all the information. To answer your question, $275 shipped.

[@thebriarking9851]

Subscriber #400