Using the Unified 2 EZOffset Wizard - Offset + Twist Compensation

  Рет қаралды 473

TH3D Studio

TH3D Studio

Күн бұрын

Пікірлер: 9
@TheOneOriginalJackal
@TheOneOriginalJackal 2 ай бұрын
I was literally just wondering what the proper procedure for this is...are the 3 values an average at the end? Or are they remembered as independent offset corrections and applied to the movement as it follows the mesh? Is there a best order to do these in? Gantry Level (also I do before every print, G34 in start gcode) Bed Mesh Offset Wiz.
@TH3DStudio
@TH3DStudio 2 ай бұрын
The offset is only a first time run thing. Everything else stays the same. It remembers the 3 values in the eeprom and also calcs the offset from those to generate an offset value for z.
@michaelryan8271
@michaelryan8271 2 ай бұрын
Tim, When I press done, it will drag to the next point… it will not raise up. Does it on 4.2.7 board and the V2, thoughts?
@TH3DStudio
@TH3DStudio 2 ай бұрын
It will only raise up with the bltouch or crouch because it has to deploy. If it's touching the bed you have to raise the z first before then going down to grab the paper.
@michaelryan8271
@michaelryan8271 2 ай бұрын
@@TH3DStudio got it. I am using EZabl on both printers…
@VolvoWhat
@VolvoWhat Ай бұрын
Do you run that extruder with any other hotends?
@TH3DStudio
@TH3DStudio Ай бұрын
That is the MicroSwiss NG extruder/hotend combo. It only is for use as a whole setup.
@VolvoWhat
@VolvoWhat Ай бұрын
Im using chc on mine. Why i asked.
@lugiber
@lugiber 2 ай бұрын
Hmm... CR-/Bl-Touch?! Inferior hardware?! I thought better of you! 😜 Thanks for the video!
3DMakerPro Moose 3D Scanner Followup - DO NOT BUY
2:29
TH3D Studio
Рет қаралды 740
How to treat Acne💉
00:31
ISSEI / いっせい
Рет қаралды 108 МЛН
The Beast is going home soon!
1:43
TH3D Studio
Рет қаралды 599
Shipping and Email Issues - Service outages!
2:55
TH3D Studio
Рет қаралды 231
Baby Steps for a perfect fit of 3D Printed Parts
5:07
The Newbie Maker
Рет қаралды 2 М.
OneLaser Hydra 9 Co2 Laser - Lens Assembly Walk-Through & Features
5:25
Making coffee from scratch (is hard)
38:34
NileBlue
Рет қаралды 1,8 МЛН
Nissan CVT Stepper Motor (Versa)
10:38
A Dollar And A Wrench
Рет қаралды 4,7 М.
Leaked! Discover the Details of Bambu Lab's New 3D Printer!
4:13
3D Geek Show - Impressão 3D
Рет қаралды 7 М.
3d print fixing the corners not to lift up
6:56
N SCALE DIVISION
Рет қаралды 298