V-Twin Racing Mower Engines Are Finally Done.

This is the third and last video in the racing mower engine build series. Started out buying 2 brand new Briggs and Stratton Intek V-Twins. I'll be updating the description with the parts used in the near future.

[@edwinleahy]

You can take a spare cut to length or stock pushrod, cut a couple inches off it, cut it in half and then thread each half, use a piece of allthread and two nuts and make an on the spot adjustable pushrod to measure. Idea for next time.

[@nashguy207]

Great video!!

[@Sufficient_Distance]

Requesting vintage Jantic Journal newspaper intro for future releases

[@TheJanticJournal]

Haha, i was really close to throwing it in for this video! Will definitely put it in for the next one, thanks for the support!

[@exhosrage4603]

I’m building a brigs 22hp v twin and I’m not sure how to set up the foot pedal for throttle. It’s a speed way motors petal. But can you show me how you do the throttle assembly for racing.

[@donraabe3529]

Can I get the part number for the coil bracket for that coil? Thanks again. You have some great videos

[@vatolocal2564]

Could you let me know where you got your exhaust kit from? I ended up welding some old stuff together but needed some with proper bends.

[@Zachmansd]

Did you have to shim the starter any to have good mesh between the gears? I worked on and raced a friends SP a couple times and had to shim the starter with a couple washers.

[@henryrebane241]

Have you tried mounting an OEM starter on Briggs Model 28 ARC billet flywheel? Do the gears mesh?

[@HipaParts]

Awesome video about mower engine rebuilding. Are you up for a brand collaboration by the way? Hipa looks for youtubers to share more tips about lawn mower maintenance to help the community.

[@berndtslawncare4906]

Question, I’m looking for oversized pistons for a 35 hp vanguard. Any suggestions where I can find them? I can’t seem to find them anywhere. Looking for .020 over or larger

[@chrisbangsund3788]

Any of your used parts for sale ?

[@scottwatrous]

Screw the haters, Bridgeport Arbor Press ftw.

[@TheJanticJournal]

Haha, I'm sure the machine has had worse over the years

[@donraabe3529]

You have the part number for that coil? Thanks

[@TheJanticJournal]

591459 is the Briggs number. Just keep in mind its straight end with no boot. Not sure if they sell them ready to go with a 90 degree boot already on them.

[@donraabe3529]

@@TheJanticJournal 👍