2006-2012 Toyota RAV4 Rear Wheel Bearing Hub Assembly (How to) Replacement

[@christinayang1611]

great job and thanks for sharing safe me alot of money going to a shop

[@BartSparrow123]

Excellent video. Just what I needed. This is so simple for an AWD car bearing.

[@MavHunter20XX]

unless its rusted in there good. Might need a slide hammer puller or a lot of percussive action.

[@rcf8367]

Good vid, Toyota makes that almost painless!

[@wish2fish37]

Thanks…My 2008 drivers side dust plate on rear is rusting thru.Unfortunately have to pull bearing to replace.Tried to find a Dorman one that is a split unit so it can get slipped on after removing bearing bolts.Ever do one ?Also did you inspect the rear k frame support on that probably right where you jack stand was is where they rust out.Replacing mine as we speak,Not cheap.Common problem on these.

[@ryanorsbornesr7651]

Like your video. Hope you make more

[@ValleyMobileAutomotive]

@@ryanorsbornesr7651 Thanks! 🙂

[@MySanti29]

Great video 👍thanks for posting it.

[@husseinlodhee2357]

❤watching from France...Very clear explanation and video..THANKS SIR...

[@ValleyMobileAutomotive]

Welcome! Glad you found this video 🙂

[@jg11596]

good video - thank you. how long is this job to complete?

[@ValleyMobileAutomotive]

I feel this can easily be done in less than two hours.

[@MrSeminolefan1122]

My axle doesn't push in at all! Tried beating with a 5 pound hammer and everything. The bearing is stuck to the axle. Help!

[@ValleyMobileAutomotive]

Ah man! I've had that happen on vehicles before. You might need to use heat like an oxygen acetylene torch on the axle. Then replace the axle and bearing at the same time.