Refill Samsung CLP415 CLX4170 504S Toner cartridge

How to refill and repair the toner cartridge for laser printers and multifunctions Samsung XPRESS C1810W Xpress C1860FW CLP-410 CLP-415 CLX-4170 CLX-4100 Series CLX-4195 CLT-K504S CLT-M504S CLT-C504S CLT-Y504S Y504 C504 M504 K504 CLT-504
What you need:
- Toner
- Chip
- Drum (if damaged)
How to clean a drum:
• How to Clean an OPC Dr...
Toner cartridges troubleshooting guide:
• Toner Cartridge Troubl...
For any question or suggestion leave a comment
-----------------------------------------------------------------------
email: [e-mail]
other links:
www.emmegiricambi.it/
-------------------------------------------------------------------------

[@alexl4607]

Nice of you to share many years of your knowledge in your videos, information is really useful, thank you

[@DJ_Megahertz]

Probably the best detail video I’ve ever seen! Thank you for sharing! One question, after what point is it absolutely necessary to take these steps versus just refilling the cartridge and putting a new chip in? Is it after two or three refills that you’ll need to start doing this type of maintenance? I have refilled all of our cartridges one time already and so far they’re still printing very well. I’m assuming at some point I’ll have to start taking them apart as shown in your video. .

[@viandant5]

I's a quite simple cartridge that prints only a thousand of copies, probaly 2-3 times if the toner roller blade does not become dirty

[@pprtp]

Thanks for your very well explained information. I cleaned the drum and still having half page not clearly printed! what might be the main reason for this issue? Thanks again

[@viandant5]

The problem could be the transfer belt. the defect is related to all colors?

[@jagath2005uk]

Thank you for very informative video. I have a issue with these cartridges. I use original Samsung 504s toner cartridges but two of the cartridges not working properly. It seems like the issue is with the developer roller. the toner covered developer roller shows small lines throughout. when the print comes it shows lines full width of the paper parallel to the direction of the paper movement. I tried cleaning the rollers, doctor blades and sealing blades but no change. I have this issue for two toner cartridges. What is the reason for this? Is this a problem with "developer roller"? If so where can I buy developer roller?

[@viandant5]

the metal blade of the developer roller is defective, or the developer roller is damaged,, for that defect there is no other possibility. I think the problem is the doctor blade

[@kadec100]

my HP 179fnw and 181fw can still run after refilling without changing chip, just set on the printer menu. can we do the same on samsung catridge? is there a setting on the printer to make it continue printing without changing chip?

[@viandant5]

No, the chip is different

[@aithamoujihad2723]

Hii sire can i use the powder color of hp 1025?

[@viandant5]

you can use HP CP1215 series

[@infokir]

Thank you for this useful video! But I faced the following issue. My clp-415nw printer has about 40% of toner and the cartridges are all original (bought with the printer). Recently it started to show red dirt on the prints - sometimes at the left side and sometimes on all the paper surface when the printed image contains red elements. Could you please advise and assist how could I clean/fix it? flic.kr/p/22fTxGV

[@viandant5]

Starter cartridges have very little toner on them, I think the problem is the magenta toner cartridge even if it's at 40%