Some EDC17CP14 readed by Kess in boot read only partial read, but with Ktag always read a full read.
@YOYODiagnostic Жыл бұрын
👍
@valentinlazar20499 ай бұрын
03L906022B kess obd ok?
@alesmachalicky27749 ай бұрын
With original yes. With clone you need VR file from 09 year.@@valentinlazar2049
@danielsvamp Жыл бұрын
Why not read by obd?
@otay1991 Жыл бұрын
i have EDC17CP14 after reading with Ktag it shows Error : serial programming activation
@lowrider69yearsago58 Жыл бұрын
How many amps the power supply needs to be? I found a good one for 50€ with 2amps. Should that be fine?
@YOYODiagnostic Жыл бұрын
Yes , 2A it's ok.
@lowrider69yearsago58 Жыл бұрын
@@YOYODiagnostic thanks a lot
@YOYODiagnostic Жыл бұрын
@@lowrider69yearsago58 You are welcome.
@mustaphaessahihi17622 жыл бұрын
Can you read this with clone PCMFLASH without opening the ecu?
@YOYODiagnostic2 жыл бұрын
Hello. I don't have PCM Clone. I don't know for sure 😊
@mustaphaessahihi17622 жыл бұрын
@@YOYODiagnostic Yes I have just received that device and it can do that
@YOYODiagnostic2 жыл бұрын
@@mustaphaessahihi1762 Thanks for the information shared with us. 👍
@mmfix38512 жыл бұрын
Question do you know which pin on CPU is boot and is the boot pin is same to other ECU? im trying to read one CPU that is same but there is no schematic on boot ? Thanks !
@YOYODiagnostic2 жыл бұрын
Hello. If the CPU is the same then the Boot pin is the same, imagine that if you should have read the order of the pins in the programmer it will always be the same if it is the same CPU
@mmfix38512 жыл бұрын
@@YOYODiagnostic ok thats good only need to remove one CPU of known ecu to see boot to which ball going i also have pdf for a tc1769 but can not understand where is boot. Thank you !
@SRBIN722Ай бұрын
Can you send me the flash memory from this computer, I need it