Waking Up a Flat Lithium Battery in Safe Mode | iTech 120X | LifePO4

[@lukehutchinson6754]

Nice work, I am yet to have the joy of a lithium set-up but still good to know for the future or to help others. 1 tip for your set-up would be to have a main isolate for input and output to make the wake up process a bit easier. Cheers 🍻

[@OutNAboutAustralia]

Hey Luke, Thanks for the suggestion mate, I currently have a main circuit breaker mounted behind the false wall, probably would’ve been smart to mount it to the front 😂

[@neilbates8409]

Thanks Mate I was wondering how you did it. it’s interesting. My 120x went into sleep mode sometime ago. Not really knowing what I was doing I just disconnected the positive from the battery reconnected it and away she went. Not sure how and this has happen twice

[@OutNAboutAustralia]

No worries Neil, not sure how that happened but I’m glad it came good for you both times 👍🏽

[@Yukonjackman1]

Technical question So will it work for a 48 volt 30 amp battery if i use a 48 battery for a trigger ?

[@OutNAboutAustralia]

Hey Gary, in short, yes your battery could use a 48V trigger from another battery, then can continue a proper charge from a 48V battery charger

[@AseanNomad]

does the Orion go ok being mounted on marine carpet?

[@OutNAboutAustralia]

No dramas at all. It does get warm but no where near enough to cause any issues.

[@AseanNomad]

@@OutNAboutAustralia ok, thanks for that

[@nivid01]

Absolute nonsense disconnecting everything!

[@dogdazetravellergarrett1367]

I agree........ Just jumpstart from starter battery...... Period. The bms just needs a constant voltage above 12 volts +/-.....,then once bms is active again, you're done.😎