Washer Diagram Troubleshooting

The best way to get good at reading diagrams is study one every day, Keep learning.

[@volpe1970]

Thanks Richard. I am trying to watch all your videos and I learn so much from every one!

[@robertakerman3570]

I learned that sand floats(joking ha-ha).

[@JOEZEP54]

I am trying but could use your help. I have a Kenmore 90 Series washer. After completing one load of wash I started a second. The tub filled with water, agitated then stopped. No matter what setting I put it in nothing happens. No humming, nothing. Another Kenmore 90 series washer was given to me. It agitated but no spin. After checking it out it was only a loose wire. Plugged it in & it went through the cycles. Put a load of cloths in & the only cycle that will now work is the spin. Any help on either one of these would be appreciated. I did notice same series but different timer control model. I did check the lid switch, both are good. I even jumped them to make sure. I installed a new controller on the first one & it will only fill with water. I checked both capacitors they are good.

[@seanstrickley3992]

Can u pls do a video on component identification and where the circuits are on the components and how to test the components. From pin to pin. I know u know what i mean i just need to know where on the schematics that point is on the component

[@DuaneFrees]

I need to fine the great that moves the agitator

[@rafaelretiz6267]

Where’s your school at?

[@rafaelretiz6267]

Heater on a washer?? Really?