The pump and zone valves are normally better on the return side of the boiler as the water is cooler on the equipment. Good job.
@Rainmaker884 жыл бұрын
Debateable if that was ever the case but now a days there’s 0 reason to not pump away
@johnguerrero43052 жыл бұрын
Why are all plumbers stuck on having the circ pump on the supply?!!! I swear it drives me nuts!!! Weil McClain clearly lists two locations on their boiler, you can have the circ. Pump: on the supply and on the return. They will re-pipe the whole boiler to make sure the pump is on the supply!! In 35 years of installing boilers, I’ve never installed a pump on a supply and I’ve never had flow issues! Please stop!!!
@jeffreyjohn2037 Жыл бұрын
It doesn't matter where the circulator is. Just make sure that you have a good air separator.
@JamesSmith-rl7nb2 жыл бұрын
Bas location for make up water??? Injection should be on supply line after pump discharge to insure air removal from purge station on return line or pump inlet
@jeffreyjohn2037 Жыл бұрын
You obviously don't know what you're talking about. Regards, third generation oilman guru and steam heating contractor.
@ianwilson19863 жыл бұрын
I need this set up only difference is my pump is on the supply
@moresmores91724 жыл бұрын
do monoflow systems with finned tube baseboards react well to purging or dou you have to vent each baseboard?
@jpheatingcoolingllc.66204 жыл бұрын
It depends on the purging setup and how large the system is. On this system I was able to purge all the air at the boiler because I setup the purge the way I wanted it and the system itself was small. But most of the times on a repair the boiler has a basic purge setup that is pretty useless so it usually requires purging each loop at the radiation to get all the air out.
@ML-lg4ky5 жыл бұрын
What was the complaint for changing the piping? Airbound?
@jpheatingcoolingllc.66205 жыл бұрын
Yes
@mikev.1034 Жыл бұрын
👍👍
@stifflers69mom15 жыл бұрын
Dose a mono flow system mean that it’s only one zone?
@ML-lg4ky5 жыл бұрын
No Name mono flow is the term used for special fittings that feed supply and return water to the emitters off 1 loop.
@stifflers69mom14 жыл бұрын
Mike L thank you
@stevestratton18883 жыл бұрын
After the repiping you did on this boiler you probably wouldn’t even have to purge, the new air separator and pump location would most likely be enough to eliminate any air in the system on its own.