Wet Okole Installation Tips

[@billmcstay194]

Supervisors jaw dropped in an interview when I told him I was a "KZbin mechanic", he had been an instructor at WyoTech... I learn at an alarming rate using KZbin... way more helpful than my fancy college degree. Thanks Troy !!!

[@RanchFairy]

It’s amazing how much info is out there

[@CharlesHenegar]

Troy I have a 2022 GMC Canyon WT Elevation series crew cab I also purchased Wet Okole front bucket seat covers. My biggest problem was routing the straps that hold the seat bottom cover left to right. The front to back straps were not a problem. I solved the left to right or side to side issue by using a 12-14 inch zip tie through the buckle on the door side strap. it's strong but flexible and can be maneuvered under or around seat framing or wire bundles. Once I had the strap routed properly I just slid the zip tie back out of the buckle made the connection and tightened.

[@MrBowNaxe]

Good stuff Troy! Always learn something watching other people finding all the trouble spots. Thanks for sharing.

[@northernmonkey4632]

Glad to see the new truck! You will be so happy with it! I have an ‘08 Tundra and has given me no issues! Looks sharp sir!!!

[@tannerhinds2321]

Troy, I don't know if you did this for the headrest holes but cutting an "X" over the receiving hardware slightly smaller than the hardware itself made it super easy to finagle it under the hardware. Again I don't know if you did that and with those type of seat covers you'll probably never have to do it again haha! Thanks for the content

[@RanchFairy]

I didn’t but maybe I should have

[@xarcher1]

On my F350, there was literally no hand room under the electric drivers seat to thread all the straps thru the gear. I actually ended up unbolting the seat, pulled it out and set it up on a work table.

[@RanchFairy]

Oh MY! Wow

[@theroguecoach]

this was so helpful!! thank you.

[@KanakaUso96792]

Wet okole a Hawaii product thank you for your review 🤙🏽

[@americandeadhead5025]

You don't want that side strap going over the seat frame. Tuck it between the seat and frame. My advice with these covers is to set them in the Sun for a few minutes. I put mine in the dryer but I know people will probably not like that. I dried my wetsuits my whole life with no problems

[@Kurtdog63]

My experience with seat covers is that after using them for a while, they start changing geography. Hopefully this kind will stay in place. Look nice.

[@RanchFairy]

That’s my hope and that’s my experience

[@laurabuzianis219]

Thank you! Aloha

[@michaelharriman2794]

I've done it before on my older Ford trucks is it too much work to get the seats out of your Dodge the two front bucket seats on my F350 came out fairly simple made it a lot easier just a thought

[@michaelharriman2794]

Oh my bad I'm old and my hearing is not that good I thought you said quad I was thinking of the four-door Dodge

[@chamisi]

so I put wet okole's in my land cruiser and seemed easy but in my tacoma I did unhook the coin catcher part on the back side of the seat back do I leave it folded up ? when I put the wet okole seat back on ?

[@RanchFairy]

Yes

[@davidstokes925]

From the short glance I got, did your front seats not have plastic parts around the bottom sides? Thanks for the vid!

[@RanchFairy]

They do

[@magnumarrowarchery155]

💪🏽🇺🇸🏹

[@randymiller899]

Can anyone send me Troy's email Thanks.