What will it make? Our Official Corvette Z06 Track Car on the Dyno - feat. Joe "The Boss" Gunn

[@paulwaite8019]

Joe is the Boss!

[@wallyalberto6275]

This car is never a trailer Queen. It pulls its own trailer With tools fuel and tires. Also a street car

[@gloriousrunningpotato]

Good job guys ! cheers from Ottawa.

[@CornFedZr1]

that's what I call the perfect track car

[@chrisb236]

Is there a way to get the full build list? I mean every single thing that was done?

[@douglastross4595]

👍

[@chrisb236]

What made you guys with a full coilovers rather than going with different struts only and keeping the leaf springs? Do you find on track that there is rubbing with wheels that wide under full corner load? Thinking about making a track car very similar to yours. What would you expect a built like that to cost? Would it be easier if I just gave you guys a call?

[@internationaldynoauthority693]

This is a Model Z 06 from 2006, and, there are no leaf springs

[@internationaldynoauthority693]

Yes, you can give us a call anytime

[@carado1984]

Tq seems a little much, like 50 ft lbs too much.

[@internationaldynoauthority693]

Based on what compression ratio? Based on what camshaft? Based on what cylinder heads? Based on what fuel?

[@carado1984]

Based on I've never seen a stock cube ls7 make over 600 wheel tq on any combo listed above. I understand the dyno is just for tuning, I don't get caught up in numbers, but either something is off or whatever you did is the greatest combo I've ever seen on an LS7.

[@carado1984]

@@internationaldynoauthority693 also don't take this negatively. I have an 08 stock compression GPI ported heads, 232/252 .648 .639 114, ARH 2 inch catless into a Borla ATAK, Ported MSD/103/MF103. It's just an observation that I've never seen that much TQ from stock cubes or even a 440.