Whiteline bushing install. For GX470, 4Runner, Tacoma, and FJ. (Part 3)

[@ClearWater7.62]

Hi do you need an aftermarket camber bolts for the white line bushings or stock is fine?

[@Povfishingtx]

stock was fine.

[@HaywoodCrossJr]

Was this for gen 2 Tacoma? Or gen 3? Do you think they will work for gen 3 2016+?

[@runningbean]

Could you not press both bushings in with the vice?

[@Povfishingtx]

Probably could have but my vice wasn’t bolted down so couldn’t take the force (clamps on table). I have the press available so no problem not to use it. Thanks for viewing!

[@runningbean]

@@Povfishingtx So a better/stable vice would have made it possible? You make it look so easy, all the forums say just replace the LCAs, but im all about diy and saving $$$. Why didn't you replace ball joint, and is that as "easy"...¿

[@Povfishingtx]

runningbean ball joints were still good. I’m all about DIY and saving money when I can too. If you’re mechanically inclined it’s not bad at all a larger more stable vice would work. I would never replace the whole arm just to get new stock bushings that would need replacement again eventually. Whitelines have lifetime warranty too.

[@pingpong909]

@@Povfishingtx how are the whitelines holding up? ive read some people have issues with them not being so snug..

[@dmelnichuk]

Freeze the bushings

[@ClearWater7.62]

Do also need to heat the control arm?