Very informative video, thank you for taking the time to film and upload it.
@petersvideofile2 жыл бұрын
I just want to say this video was excellent! I wish more support videos were as concise, well illustrated and thorough as this video! I feel this should have many more views than it does!
@HARD88LUCK2 жыл бұрын
Very underrated video but has heaps of very useful info! Must watch for new comers
@chanceym60002 жыл бұрын
could this be caused by extra strain on the motors because of too-tight belts?
@1x93cm2 жыл бұрын
Thank you
@Printerguy3608 ай бұрын
A mask I was making shifted a full 10mm and then finished printing flawlessly.
@Printerguy3608 ай бұрын
Belts are tight. It was a 26 hr print on Ender 3.
@7ifestyleАй бұрын
@@Printerguy360you ever figure it out
@yu-yaokao3773 жыл бұрын
Qma Galadriel channel just come back to visit your channel :)
@gravity-less3dprinting6243 жыл бұрын
Thanks for support
@yu-yaokao3773 жыл бұрын
@@gravity-less3dprinting624 Welcome to come to visit my channel:)
@chrisbell6849 Жыл бұрын
No sound Feb 23
@ismaelaguilarortega47323 жыл бұрын
I am having these issue just on the y axis, trying to solve it right now.
@gravity-less3dprinting6243 жыл бұрын
Good luck, my friend🙂👍
@ericvail65283 жыл бұрын
Try going into your firmware settings and lower your “y” axis speed. That is if you have checked belt tension and pulley already.
@jefferylittleton10053 жыл бұрын
Did you solve it? I have the same problem.
@ericvail65283 жыл бұрын
@@jefferylittleton1005 I solved all of my issues. Ended up being the crap drivers on the 4.2.2 board. Upgrades to a 4.2.7 with branded German made driver chips and all issues are gone.
@jefferylittleton10053 жыл бұрын
@@ericvail6528 this is what I was thinking considering it started all at once without any mechanical changes, and that small prints are usually okay. Thanks for the advice!