Wireless Conversion Dump Trailer using Harbor Freight winch remote

[@commonsensepatriot9450]

Wow! Finally, it's a super simple description of how to do this. No diodes or complicated explanations. Thanks.

[@popapoco]

You did it perfectly, you can also put a manual valve on the gravity down to slow the box when it has a heavy load or open the valve to allow more oil through when it is cold. I always thought gravity down was better but you hear everyone bragging about their power down lol good job

[@PNWTone]

Amazing. Very descriptive and slow and easy. Thank you

[@Dubs38]

If I wanted power down. I would put the white wire on the power down and eliminate the jump wire?

[@Todd408.]

Did you try that? Bc I still wanna power down.

[@chrisdoss8553]

This wiring Method Works perfectly if you have a dump trailer that is power up and gravity down. If your trailer is Power up and gravity down you do not need the diodes. However If your trailer is power up and power down you will need To use the diodes. So in that case use the instruction video Which Instructs you to use the diodes.

[@Todd408.]

Where do we find that?

[@troyunderhill3588]

Wired as you show but my pump motor surges on and off rather than maintain a constant lift. What’s causing this?

[@troyunderhill3588]

Bad ground... All fixed and works great!

[@jacksonthomas5030]

Nice 😷 ? Can this same system work on single stage pump 😁

[@Flienlow]

My wiring is different. Black, brown, blue, geen (striped) My wires are also tiny compared to what you have there.

[@adamdivine]

So I got this wired up today power up gravity down. How do I get power down? When I gravity down all of my fluid came shooting out of the reservoir cap.

[@briangates8681]

I agree this is a problem I don’t recommend the gravity down at all!! There is another video out that shows you how to do power down it uses diods it’s same harbor freight remote I’m doing mine now

[@fabianofarina4718]

Thank you Sr,your video helps me a lot

[@brianvassar2556]

I would keep the wired controller in there In the moment you need it most the batteries in the remote will die

[@Flienlow]

I cannot get mine to work. I can get it to only go down. If I reverse, I can only get it to go up.

[@kyleturner3999]

Do you know what size the fuse is on the signal box?

[@adamdivine]

20mm 3.5 amp

[@groovychik601]

I believe you got your selonoid backwards

[@timothycarey4629]

How can i wire it with power up and down i have 2 relays i can use

[@jonathanriddle5319]

Did you figure out powering down also?

[@hernandez660r]

Something is not working for me

[@timothycarey4629]

I have 2 30amp 4 pin relays it's power up and down but they back feeding when you hook up both i can get it to work gravity down but want power down can anyone help me please

[@johnsandlinjr]

Need some diodes buddy. Put diodes on the up and down jumpers over to the pump. Then it won’t back feed